Hanging the FAN

Panama® Halo

Step 4. To hang the fan body in the canopy, hold the fan body firmly and insert the ball into the canopy opening. Check that no wires were pinched. Rotate the fan body until the slot in the nylon ball fits into the pin opposite the canopy opening.

Note: Independent control of the light fixture using a W-81 re- quires an additional power wire run from the wall switch to the fan. See Page 10 for wiring.

ball

slotpin

Fan Weighs 27 lbs

CANOPY ELECTRICAL CONNECTIONS

Step 4a. Attach the fan wires to the ceiling fixture outlet box wiring by twisting the bare ends of the wires together and then securing with a wire nut. Test that the connection is secure by pulling on the wire nut. Conect in this order:

Step 4b. Wiring Connections

•GREEN leads from mounting plate and fan to GROUND conductor of power source. Secure with wire nut.

•WHITE wire from fan to white NEUTRAL wire in ceiling fixture outlet box. Secure with wire nut.

•BLACK power wire from fan to BLACK power wire in ceiling outlet box. Secure with wire nut.

2 BLACK WIRES

2 WHITE WIRES

3 GREEN

WIRES

CANOPY HATCH INSTALLATION

Step 5. Tuck the wires into the canopy with the wire nuts pointed upwards, so that the WHITE and BLACK wires are on opposite sides of the canopy and all wires are clear of the canopy opening.

Step 6. Install canopy hatch with the last canopy screw and lock washer. To do this, tilt the fan body away from the hatch opening.

Tighten the screws firmly by hand only,

Step 7. Straighten the fan, then check to ensure that there is no movement between the canopy and ceiling or Hang-Tru ball and top support shaft.

canopy

hatch

lock washer

canopy screw

tilt the fan to install

last canopy screw