Casablanca Fan Company PSG73M owner manual Hanging the FAN, Canopy Electrical Connections

Page 8

HANGING THE FAN

Step 8a. To hang the fan body in the canopy, hold the fan body firmly and insert the ball into the canopy opening. Check that no wires are pinched. Rotate the fan body until the slot in the ball fits into the pin opposite the canopy opening.

Step 8b. Trim excess motor wires, leaving at least 6 inches above the downrod. Strip 1/2-inch insulation from the end of each wire using a wire stripper (available at your local hardware store).

Ball

 

Slot

Pin

 

CANOPY ELECTRICAL CONNECTIONS

Step 9. Attach the fan wires to the ceiling fixture outlet box wiring by placing the bare ends of the wires side by side and then securing with a wire nut. Test that the connection is secure by pulling on the wire nut. Connect in this order:

GREEN leads from mounting plate and downrod assembly of fan to GROUND conductor of power source. Secure with wire nut.

WHITE wire from fan to white NEUTRAL wire in ceiling fixture outlet box. Secure with wire nut.

BLACK power wire from fan to BLACK power wire in ceiling outlet box. Secure with wire nut

Wire Nut

2 Black

Wires

2 White

Wires

3Green Wires

NOTE: If the color of your ceiling wires differs from that described, consult an electrician.

CANOPY HATCH INSTALLATION

Step 10a. Tuck the wires into the canopy with the wire nuts pointed upwards, so that the WHITE and BLACK wires are on opposite sides of the canopy and all wires are clear of the canopy opening.

Step 10b. Install the canopy hatch with the last canopy screw and lock washer using the provided screwdriver. To do this, tilt the fan body away from the hatch opening. Tighten the screws firmly.

Step 10c. Straighten the fan, then check to ensure there is no movement between the canopy and the ceiling or the Perma•Lockdownrod and the ball assembly.

8

Image 8
Contents Read and Save These Instructions Contents Unpacking Introduction Before YOU StartSafe USE Sloped Ceiling Installations Mounting Recommendations General GuidelinesUsing Existing Ceiling Fixture Outlet Box Crossbar Mounting Bracket InstallationInstalling a New Ceiling Fixture Outlet Box LAG Screw Installation Canopy InstallationPrepare for fan installation as follows FAN PreparationNo Light CAP Option Blade InstallationInstallation/Replacement of Incandescent Lightbulbs Canopy Electrical Connections Canopy Hatch InstallationHanging the FAN Light KIT Installation Light Assembly InstallationInstall Glass Shades Install Incandescent LightbulbsVERSATOUCH2 Control Installation Control Bracket InstallationStandard Light Switch Wall InstallationChanging Transmitter Frequency Setting Remote OperationTroubleshooting Tips Care Recommendations Fan FinishesBlades No Need for LubricationAuthorized Service Centers AlabamaKentucky Product Specifications