Casablanca Fan Company 6643050 specs

ADVAN•TOUCH™

SAFETY FIRST

Warning:To reduce the risk of electrical shock, this fan must be installed with an isolating wall control/switch.

ADVAN•TOUCH W-62 BRACKET/HOLSTER REMOVAL

Step 1. Remove the two 6-32 x 5/16” screws holding the bracket to the holster. Save screws for later.

HOLSTER BRACKET

ADVAN•TOUCH CONTROL BRACKET INSTALLATION

CAUTION! Do not use with wall dimmer.

STANDARD		ROCKER
TOGGLE		ROCKER
SWITCH		TYPE
		LIGHT
INNER		SWITCH
INNER	OUTER
MOUNTING	OUTER
HOLES	MOUNTING
	HOLES
SWITCH		SWITCH
COVER		SWITCH
PLATE	CONTROL	COVER
CONTROL	CONTROL	PLATE
BRACKET	BRACKET
BRACKET

Standard Light Switch

Step A. Remove the two screws holding the switch cover

plate. Do not remove the cover plate.

Step B. Orient the control bracket as shown and line up the two inner mounting holes with those on the switch.

Step C. Install and tighten screws by hand only.

Wall Installation

Step A. Locate a 2x4

wall stud in a convenient

location.

Step B. Orient the control bracket as shown over the

Rocker Light Switch

Step A. Break off the two tabs by pushing outward.

Step B. Remove the two screws holding the switch cover

plate. Do not remove the cover plate.

Step C. Orient the control bracket as shown and line up the two inner mounting holes with those on the switch.

Step D. Install and tighten screws by hand only.

Note: The wall anchors and 6-32 x 1” screws may be used in situations where mounting to a stud is not pos- sible. Use the inner mounting holes. After securing the anchor, discard the anchor’s pointed screws and use the 6-32 decor ovalhead screws supplied.

2x4 stud.

Step C. Use the 1” wood screws in either the inner or outer mounting holes.

Install and tighten screws by hand only.

ANCHOR PANHEAD SCREW

WOOD

SCREW 1”

DRYWALL ANCHOR

DECOR OVALHEAD SCREW

6-32 X 1”

ADVAN•TOUCH ATTACH HOLSTER TO BRACKET

Step 2

After you have completed installing the bracket to the wall, using the 2 screws removed in Step 1, attach the W-62 holster to the bracket.