Canopy Electrical Connections

Step 6a. Attach the fan wires to the ceiling ﬁxture outlet box wiring by twisting the bare ends of the wires together and then securing with a wire nut. Test that the connection is secure by pulling on the wire nut. Connect in this order:

Step 6b. Pull Chain or W-41 Wiring Connections

•GREEN leads from mounting plate and fan to GROUND conductor of power source. Secure with wire nut.

•WHITE wire from fan to white NEUTRAL wire in ceiling ﬁxture outlet box. Secure with wire nut.

•BLUE wire and BLACK power wire from fan to BLACK power wire in ceiling outlet box. Secure with wire nut.

Step 6c. W-81 Wiring Connections

•GREEN leads from mounting plate and fan to GROUND conductor of power source. Secure with wire nut.

•WHITE wire from fan to white NEUTRAL wire in ceiling ﬁxture outlet box. Secure with wire nut.

•BLACK power wire from fan to RED wire from W-81 in ceil- ing outlet box. Secure with wire nut.

•BLUE wire from fan to YELLOW wire from W-81 in ceiling outlet box. Secure with wire nut.

NOTE: See Page 8 for additional wiring information.

WIRE NUT			PULL CHAIN OR
			W-41 CONNECTIONS

2 BLACK & BLUE

D1-OPTION WIRES (WITHOUT W-81)

2 WHITE WIRES

3 GREEN WIRES

W-81 CONNECTIONS

BLUE & YELLOW

WIRES

BLACK & RED

WIRES 2 WHITE WIRES

3 GREEN WIRES

CANOPY HATCH INSTALLATION

Step 7. Tuck the wires into the canopy with the wire nuts pointed upwards, so that the WHITE and BLACK wires are on opposite sides of the canopy and all wires are clear of the canopy opening.

Step 8. Install canopy hatch with the last canopy screw and lock washer. To do this, tilt the fan body away from the hatch opening.

Tighten the screws ﬁrmly by hand only,

Step 9. Straighten the fan, then check to ensure that there is no movement be- tween the canopy and ceiling or Hang-Tru ball and top support shaft.

CANOPY

HATCH

	LOCK	TILT THE
	WASHER
		FAN TO

	CANOPY	INSTALL
		LAST
	SCREW
		CANOPY

		SCREW

BLADE HOLDER & BLADE ASSEMBLY

Step 10.

Attach the blades to the blade holders with the three blade screws and felt washers provided for each blade.

Hand tighten securely.

Install the assembled blade and blade holder to the motor.

Hand tighten securely.

Repeat for each assembly.

BLADE HOLDER	BLADE SCREW
BLADE HOLDER	(3 PER BLADE)
SCREW
(2 PER BLADE
HOLDER)	FELT WASHER
	(3 PER BLADE)

BLADE

WARNING: To reduce the risk of personal injury, do not bend blade holders when installing, bal- ancing, or cleaning. Do not insert foreign objects between rotating fan blades.

PROCEED TO YOUR FAN’S CONTROL FEATURE SECTION FOR INSTALLATION/OPERATING INSTRUCTIONS:

4-SPEED - PAGE 7 INTELI•TOUCH2 - PAGE 9