Security Feature

ADVAN•TOUCH™

Pressing the ‘SECURITY’ button will start the Security lighting program. The controller beeps and indicates ‘SECURITY’. The light will automatically turn ON and OFF in a seemingly random manner over an eight and a quarter hour programmed cycle that is designed to give the home a “lived-in” look.

Regardless of the light setting when switching to the Security mode (lights on or off, dim or bright), the lights will increase to high brightness and then begin the Security cycle. This cycle is then repeated continuously until cancelled by pressing the ‘SECURITY’ button.

At any time during the Security mode you may adjust the fan speed, reverse the direction, operate in Auto Speed or Winter, use Saver or run the Test mode without affecting Security mode.

You may still turn the light ON and OFF (or OFF and ON) manually for temporary lighting, but the light will continue to operate automatically at its programmed times.

SECURITY MODE CYCLE

1.	On for 60 minutes (80% bright)	4. Off for 60 minutes
2.	Off for 30 minutes	5 . On for 90 minutes (50%
3.	On for 120 minutes (30% bright)	bright)

ADVAN•TOUCH CHANGING FREQUENCY SETTING

Note: All fans leave the factory set to ‘10000’.

You will have to change the dip switch settings in the remote if you are using more than one fan in the same area and want to control them separately.

+–

Step 1. At the circuit breaker or fusebox, turn the power off for the fan you want to change.

Step 2. Open the battery door of the Advan•Touch control and remove the ﬁrst battery on the left to gain access to the dip switches.

Step 3. Change the dip switch settings, assuring that they are

different from the previously installed Advan•Touch fan(s). Step 4. Re-install the battery in the proper polarity and the

battery door on the control.

Step 5. At the circuit breaker or fuse box, turn the power back on for the fan whose frequency you are changing.

Step 6. Within 20 seconds of restoring power, push the

up and down buttons at the same time. Hold for a few seconds. You will see the LCD Screen ﬂash all of the graphics. You should now have control of the fan.

1	ON
2
3
4
5	ECE

DIP SWITCH

LOCATION

	A4

	+
1		ON
2
3
4		ECE
5

–

Note: You may want to label your controls to assure you do not mix them up.

ADVAN•TOUCH IF THE FAN DOES NOT WORK

If the fan is not functioning after installation:

Step 1. Check to make sure the batteries are installed properly in the control.

Step 2. Turn the power off to the fan (from the circuit breaker) for at least 5 seconds.

Step 3. Turn the power back on (at the circuit breaker) and push the up and down buttons at the same time, within 20 seconds from restoring power.

Step 4. The fan should now function properly.