ASSEMBLY
Attaching Pin on Bucket
Material bucket can be installed using tool ordinarily available.
1.Attach bucket to lift boom frame and cylinders with four 1” pins, using a 3/8 shoulder bolt and 3/8 lock nut to secure each pin. Use upper bolt hole in bucket mounting ear for shoulder bolts on two lower pins.
2.Install level indicator rod in level guide tube on right bucket cylinder. Sandwich level indicator rod angle between right inside bucket ear and cylinder rod end.
3.Set bucket level on ground and adjust level guide tube along bucket cylinder until end of guide tube is flush with end of rod.
Dismounting Loader
Never crawl under or allow children to play around or on a loader that is disconnected from the tractor. The loader could fall crushing a person resulting in serious injury or death.
Do not remove the attachment from the loader when the loader is disconnected from the tractor. The attachment stabilizes the loader. If the attachment is removed, the loader will fall and could result in serious injury.
Only disconnect and store the loader on firm flat ground. Make sure the loader stands are properly installed and rest on firm ground or support blocks. If the stands sink or fail, the loader could fall causing serious injury.
1.Locate tractor and loader on firm level ground.
2.With bucket raised above ground, tilt bucket down approximately 30 degrees from level.
3.Lower boom by retracting lift cylinders to lift tractor front end (tires can be off ground).
4.Stop engine. Allow tractor front end to lower by relaxing ONLY lift cylinders with control lever. This will remove pressure on hitch pins.
Note: Do not relax bucket cylinders.
5.Set parking brake. Rotate parking stands from storage position by removing linch pins and clevis pins. Reinstall clevis pins and linch pins when parking stands are in operation position (See Figure
ASSEMBLY
2545 01/11 | Assembly Section |
© 2011 Alamo Group Inc.