Unpacking and Assembling the Machine
NOTE: Unpacking and assembling the
Parts Supplied in Crate:
•
•Safety & Operating Instructions Manual
•Briggs & Stratton or Kawasaki Engine Manual
•Small Parts Bag:
-Hitch Tongue Extender with 1/2" x 2" Bolt, Lock Nut and Washers
-Hook and Loop Straps
-Plastic hose (oil drain)
-Extra
Tools and Supplies Needed:
•Pry Bar
•Metal Shears
•Hammer
•Gloves and Eye Protection
•STABILIZE THE SHIPPING CONTAINER ON CLEAN FLAT TERRAIN BEFORE ATTEMPTING TO UNPACK AND ASSEMBLE THE MACHINE.
•ALWAYS WEAR EYE PROTECTION AND STAND TO ONE SIDE WHEN CUTTING THE BANDING. THE BANDING IS UNDER A LOT OF TENSION AND CAN CAUSE INJURY WHEN YOU RELEASE THE TENSION.
•USE CAUTION AROUND EXPOSED NAILS WHEN UNCRATING THE MACHINE.
1.Pry off and remove the top cross members of the shipping crate. Be careful of the nails when removing the boards.
2.Pry off and remove the crate sides; the two (2) long sides first, and then the two (2) short sides.
3.Stand to one side and cut any bands holding the machine to the shipping pallet and the bands holding the Remote Control Panel carton to the Push Bar. Be careful when cutting the banding.
WEAR GLOVES AND BE VERY CAREFUL WHEN HANDLING THE DECK. THE BLADES ARE VERY SHARP, AND MAY SPIN AS YOU MANEUVER THE DECK.
4.The
5.Raise the Mower Deck Height to the highest setting
6.Remove the Blade Protector from the Blades. (See CAUTION note above)
7.Do not discard your pallet and packaging material until you are fully satisfied with your new TOW- BEHIND DR FIELD and BRUSH MOWER.
CALL | 13 |