Bolens 18M Operating Your Engine, Fuel Recommendations, Check Fuel Level, Starting The Engine

Page 15

2.Insert the dipstick into the oil filler neck, but do not screw it in.

3.If the level is low, slowly add oil to the upper limit on the dipstick. See Figure 9-3 inset.

4.Tighten dipstick firmly before starting engine.

IMPORTANT: Do not overfill. Overfilling with oil may cause smoking, hard starting, spark plug fouling, or oil saturation of air cleaner.

Fuel Recommendations

Use automotive gasoline (unleaded or lowleaded to minimize combustion chamber deposits) with a minimum of 87 octane. Gasoline with up to 10% ethanol or 15% MTBE (Methyl Tertiary Butyl Ether) can be used

Never use an oil/gasoline mixture or dirty gasoline. Avoid getting dirt, dust, or water in the fuel tank.

WARNING: Gasoline is extremely flam- mable and is explosive under certain conditions.

Refuel in a well-ventilated area with the engine stopped. Do not smoke or allow flames or sparks in the area where the engine is refueled or where gasoline is stored.

Do not overfill the fuel tank (there should be no fuel in the filler neck). After refueling, make sure the tank cap is closed properly and securely.

Be careful not to spill fuel when refueling. Spilled fuel or fuel vapor may ignite. If any fuel is spilled, make sure the area is dry before starting the engine.

Avoid repeated or prolonged contact with skin or breathing of vapor.

Check Fuel Level

1.Clean around fuel fill before removing cap to fuel.

2.Fill tank to approximately 2 cm below lowest portion of neck to allow for fuel expansion. Be careful not to overfill.

IMPORTANT: Before refueling, allow engine to cool 2 minutes.

Starting The Engine

WARNING: Always keep hands and feet clear of equipment moving parts. Do not use a pressurized starting fluid. Vapors are flammable.

1.Move the choke lever on the left side of the upper handle to START position. See Figure 9-4.

NOTE: Use of the choke may not necessary if the engine is warm or the air temperature is high.

/ILI&ILL #APL $IPSTICK

5PPERP,EVEL

Figure 9-3

2

3

4

1

 

Figure 9-4

2.Standing behind the mower, depress the blade control handle and hold it against the upper handle.

3.Pull the starter grip lightly until resistance is felt, then pull rapidly to overcome compression, prevent kickback and start engine. Repeat if necessary. See Figure 9-4 .

IMPORTANT: Do not allow the starter grip to snap back against the engine. Return it gently to prevent damage to the starter.

4. When engine warms up, push in the choke knob .

Stopping The Engine

1. Release the blade control handle. See Figure 9-4.

9

Operating

Your

Engine

WARNING

Always keep hands and feet clear of equip- ment moving parts. Do not use a pressurized starting fluid. Vapors are flammable.

IMPORTANT

Do not allow the starter grip to snap back against the engine. Return it gently to prevent damage to the starter.

15

Page 14 Page 16
Image 15
Page 14 Page 16
Contents Inch Rotary Lawn Mower Model 18M 769-03084A11/02/07 Table of Contents Finding and Recording Model NumberCustomer Support Slope Gauge General Operation Your Responsibility Restrict the useSlope Operation Service General ServiceChildren Center top of bag attaches from the inside of bag Setup AdjustmentsCutting Height AdjustmentsKnow Your Lawn Mower Stopping Engine Using Your Lawn MowerOperating Your Lawn Mower Starting EngineMaintenance Blade Mounting Torque Rear Flap ReplacementOff-Season Storage Blade AdapterProblem Cause Remedy Trouble ShootingSafety Labels Pre-Operation Check Oil Recommendations Know Your EngineCheck Oil Level Important This engine is shipped without gasoline or oilStarting The Engine Operating Your EngineFuel Recommendations Check Fuel LevelOil Service Maintaining YourOil Change Air Cleaner Service Spark Plug ServiceMaintaining Your Engine Removing From Storage Fuel Filter ServiceClean Engine Storage10.30.06 WarrantyEngine/Moteur 1P70 Description Désignation Réf Parts List Pièces DétachéesFor parts and/or accessories refer to customer support on Adressez-vous au «Service après-vente»Model 18M Part RÉF Pièce Description MANUFACTURER’S Warranty Coverage EPA-1 General Conditions Owner ResponsibilitiesGénéral d’ordre Conditions Propriétaire du ResponsabilitésGarantie la par couvertes non conditions et Pièces CA-1-EPA Propriétaire DU Responsabilités 06.30.10 GarantieMoteur du Nettoyage Service en RemiseCarburant* à filtre du Entretien RemisageCartouche Air à filtre du EntretienBougie Mousse en CartoucheAvant Avertissement ’huile de Vidange’essence panne en tombe Ou moteur le d’inclinerMoteur du Arrêt Carburant le concernant Recommandations’huile concernant Recommandations Moteur le avec vous-Familiarisez’huile niveau du Vérification Sabilité -RESPON Votre Sécurité de ÉtiquettesDépannage Solution Cause ProblèmeEntretien Général d’ordre Recommandations ’utilisation Conseil UtilisationCommandes Herbe Sac du haut le contre pas repose ne RéglageGuidon Figure la Voir .herbeSécurité de Consignes Faire À Responsabilité VotreArbre InclinomètreMatières des Table Vente-après ServiceVente-après service au d’abord adresser vous sans Modèle de numéro le trouver PourImportant 18M Modèle po 19 de Rotative Tondeuse 11/2/0703084A-769

18M specifications

The Bolens 18M is a versatile and robust lawn and garden tractor that has been designed to meet the needs of both residential and commercial users. Known for its durability and performance, the Bolens 18M exemplifies the qualities that homeowners and landscapers look for in a reliable outdoor equipment.

One of the main features of the Bolens 18M is its powerful 18-horsepower engine, which provides ample power for a variety of tasks, from mowing to hauling heavy loads. The engine is paired with a hydrostatic transmission, allowing for smooth and seamless operation. This feature enables users to change speed without the need for manual gear shifting, providing ease of use for all skill levels.

The design of the Bolens 18M is characterized by a strong steel frame and heavy-duty construction, ensuring it can withstand the rigors of regular use. The tractor is equipped with a wide cutting deck, typically around 42 inches, which allows for efficient mowing of larger areas in less time. Additionally, the cutting height can be easily adjusted to suit different types of grass and landscaping needs.

Another noteworthy technology in the Bolens 18M is its ergonomic steering and control layout. The tractor features a comfortable seat with armrests, enhancing the user's comfort during prolonged use. This design ensures that operators can maneuver the tractor with minimal fatigue, promoting efficiency and productivity.

The Bolens 18M also offers various attachment options, expanding its functionality beyond just mowing. Attachments such as snow blowers, tillers, and dump carts can be easily integrated, transforming the tractor into a multi-use gardening tool. This versatility is particularly appealing for homeowners looking to maintain their properties year-round.

Safety features are also a priority in the Bolens 18M design, with built-in mechanisms such as an automatic blade brake that stops the blades immediately when the operator leaves the seat, preventing any accidents.

In summary, the Bolens 18M stands out with its powerful engine, user-friendly hydrostatic transmission, adjustable cutting deck, ergonomic design, and versatility through attachments. With its solid build and thoughtful features, it continues to be a popular choice for those seeking reliable equipment for their lawn care and gardening tasks. Whether for residential use or commercial landscaping, the Bolens 18M delivers performance and innovation that users can depend on.
Top Page Image Contents