Workstation speaker
NOTE: Read Warnings and cautions on page 59 before servicing this component. This section describes how to remove and install the workstation speaker.
Removing the workstation speaker
To remove the workstation speaker:
1.Disconnect power from the workstation (see Predisassembly procedures on page 66).
2.Remove the side access panel (see Removing the side access panel on page 69).
3.Remove the front bezel (see Removing the front bezel on page 72).
4.Disconnect the speaker cable from the system board 
as shown in the figure below.
5.Remove the two screws as shown 2.
6.Slide the speaker away from the chassis and remove it from the chassis 
. Figure
Installing the workstation speaker
To install the speaker, reverse the previous steps.
ENWW | Removing and installing components 81 |
