Side access panel solenoid lock
The side access panel solenoid lock provides a method to lock the side access panel by means of a local or remote
This section describes how to remove and install the side access panel solenoid lock.
Removing the side access panel solenoid lock
To remove the side access panel solenoid lock:
1.Disconnect power from the workstation (see Predisassembly procedures on page 66).
2.Remove the side access panel (see Removing the side access panel on page 69). Remove the side access panel (see Removing the side access panel on page 69).
3.Disconnect the side access panel solenoid lock cable from the system board 
.
4.Remove the two screws that fasten the solenoid lock to the chassis 2 as shown in the following figure.
5.Pull the solenoid lock assembly inward and then up 
to remove the assembly from the chassis. Figure
Installing the side access panel solenoid lock
Reverse the above steps to install the side access panel solenoid lock. This involves connecting the solenoid lock cable to the system board and fastening the solenoid lock to the chassis.
ENWW | Removing and installing components 71 |
