3.Remove the expansion card support (if installed) by removing the two screws and lifting up on the support.
Figure 5-24 Removing expansion card support
4.Remove all cables connected to the expansion card.
5.Push down on the expansion card retention clamp levers on the inside of the chassis to open the retention clamp 
as shown below.
Figure 5-25 Removing the expansion card
Release the expansion card slot latch 2, and then carefully lift the card from the chassis 
.
6.Install a expansion slot cover and close the expansion card retention clamp.
If the expansion card retention clamp does not close, ensure that all cards are properly seated, and then try again.
94 Chapter 5 Replacing components | ENWW |
