HP VA799UT 799UT#ABA, Z400 H2D81US manual Dimm Configuration DIMMs are not installed correctly not

Table 6-10POST error messages (continued)

Screen message	Probable cause	Recommended action
214—DIMM Configuration	DIMMs are not installed correctly (not	See the service label on the workstation access panel
Warning	paired correctly).	for the correct memory configurations, and reseat the
		DIMMs accordingly.
215—DIMM Configuration
Error
216—Memory Size Exceeds	The amount of memory installed	1.	Verify how much memory the workstation
Maximum Supported	exceeds that supported by the		supports.
	hardware.	2.	Remove the excess memory.
301—Keyboard Error	Keyboard failure.	1.	Reconnect the keyboard with the workstation
			powered off.
		2.	Check the connector for bent or missing pins.
		3.	Be sure that none of the keys are pressed.
		4.	Replace the keyboard.
303—Keyboard Controller	I/O board keyboard controller is	1.	Reconnect the keyboard with the workstation
Error	defective or is not set properly.		powered off.
		2.	Connect a keyboard directly to the workstation
			(instead of through a switch box).
		3.	Replace the system board.
304—Keyboard or System	Keyboard failure.	1.	Reconnect the keyboard with the workstation
Unit Error			powered off.
		2.	Connect a keyboard directly to the workstation
			(instead of through a switch box).
		3.	Be sure that none of the keys are pressed.
		4.	Replace keyboard.
		5.	Replace system board.
510—Splash Screen image	Splash Screen image has errors.	Update system BIOS.
corrupted
511—CPU Fan not detected	Fan is not connected or is defective.	1.	Reseat the fan cable.
		2.	Reseat the fan.
		3.	Replace the fan.
512—Rear Chassis fan not	Rear fan missing, disconnected, or	1.	Reseat the fan cable.
detected	defective.	2.	Reseat the fan.
		3.	Replace the fan.
513—Front Chassis fan not	Front fan missing, disconnected, or	1.	Reseat the fan cable.
detected	defective.	2.	Reseat the fan.
		3.	Replace the fan.
514—Memory fan not	Memory fan missing, disconnected, or	1.	Verify that the memory fan is installed and
detected	defective.		connected properly.
		2.	Replace the fan.

ENWW Diagnostic codes and errors 141