Installing a CPU
NOTE: HP recommends that you do not swap processors (CPUs) from one system board to another. To install a CPU:
1.Disconnect power from the workstation (see Predisassembly procedures on page 66).
2.Remove the side access panel (see Removing the side access panel on page 69).
3.Remove the CPU heatsink (see Removing the CPU heatsink on page 101).
4.Remove the CPU (see Removing a CPU on page 104).
5.Using extreme care, fully raise the CPU socket lever and cover.
CAUTION: The CPU socket contacts are delicate. To avoid bending the contacts, use extreme care when installing the CPU in the socket.
6.Align the notches in the CPU base with the tabs on the socket as shown in the figure below.
Seat the CPU into the socket. Ensure that the underside of the CPU is level with the top of the CPU socket.
7.Close the CPU cover plate by lightly pressing down on the CPU cover plate while closing the socket lever.
8.Replace the CPU heatsink (see Installing the CPU heatsink on page 102), and then close the side access cover.
ENWW | Removing and installing components 105 |
