Installing an optical disk drive in the optical bay
To install an optical disk drive:
1.Disconnect power from the workstation (see Predisassembly procedures on page 66).
2.Remove the side access panel (see Removing the side access panel on page 69).
3.Remove the front bezel (see Removing the front bezel on page 72).
4.Lift the green release lever 
and slide the optical disk drive into the bay until it is stopped by the release latch as shown in the figure below.
Release the latch and continue sliding the drive until the latch closes and engages the drive 2. Figure
TIP: During installation the adjacent drive or filler may move slightly. It might be necessary to slide and align both devices to get the release latch to close and engage both devices.
5.Connect the power and data cables to the drive as shown in the following figure. (See the service label on the Side access panel for component locations.)
ENWW | Removing and installing components 79 |
