165, Attach handle to vacuum | Bissell 13H8 manual

Bissell 13H8 warranty 165, Attach handle to vacuum, Attach vacuum hose and tools

Page 5

Assembly

The only tool you’ll need to assemble your vacuum cleaner is a Phillips screwdriver.

Attach handle to vacuum

1.Locate the vacuum handle and remove the screw packet taped to the handle.

2.Stand the vacuum upright and from the rear of the unit, slide the base of the handle firmly into the grooves at the top of the vacuum body.

3.Ensure the handle fits firmly to the vacuum body. If there are any gaps, continue to push firmly until the handle is secure.

4.Insert the provided screw into the existing hole, attaching the handle to the body of the vacuum. Tighten securely with a screwdriver.

1.Slide the end of the hose into the hose wand base. Snap the hose into the hose clip.

Note: The vacuum will not operate effec- tively unless the hose wand is firmly attached.

2.Place the crevice tool on the storage clip on the left side of the tank (when viewing vacuum from rear.)

3.Place the contour tool on the storage clip located near the back of the upper handle.

4.Place the dusting brush on the storage clip located on the lower cord wrap.

w w w . b i s s e l l . c o m

8 0 0 . 2 3 7 . 7 6 9 1

Image 5

Contents

E R ’ S G U I D E Bissell Reward Points Efficient ServiceProduct Support Alerts We’ll contact with any important product alerts163 Important Safety InstructionsQuick Release Cord Wrap 165 Wrap power cord around cord wrapsAttach handle to vacuum Attach vacuum hose and toolsUpright for storage and above floor clean- ing with tools 167 OperationEmpty dirt into garbage container Maximize your cleaning performanceEmptying dirt container Filter Cleaning the foam motor and Hepa media filterUnplug the vacuum from electrical outlet Check rotating floor brush and drive belt Motor Pulley Replace drive beltReplace brush cover and all five screws Grasp the inner cyclone and twist to the left Cleaning the upper tankClearing Clogs Visible dirt escaping from cleaner Vacuum cleaner won’t pick up dirtVacuum cleaner won’t turn on Possible causes Authorized service representativeM. 10 p.m. ET Bissell Consumer ServicesOr write PO BoxPart Name Replacement parts Bissell vacuumIf your Bissell product should require service Warranty Bissell PowerGroom Pet CompactLimited Two Year Warranty

Related manuals