Billy Goat QB1601,QB1601SP owner manual Troubleshooting, Warranty Procedure

Page 16

20

TROUBLESHOOTING

Before Requesting Service Review These Suggestions

 

Problem

Possible Cause

Solution

Poor air performance

Air intake or exhaust clogged.

Clear clog.

 

 

 

Machine is difficult to maneuver.

Low tire air pressure.

Inflate front and rear tires to correct pressure.

 

 

 

(See tire pressures on page 14.)

 

 

 

Abnormal vibration

Loose or out of balance impeller or loose

Check impeller and replace if required. Check

 

 

engine.

Engine.

 

 

 

Engine will not start

Stop switches off. Choke lever not in on

Check switches, choke, gasoline and oil. Check

 

 

position. Out of gasoline. Bad or old gasoline.

for spark with an approved tester. Clean or

 

 

Spark Plug wire disconnected. Dirty air

replace air cleaner. Contact qualified service

 

 

cleaner.

person.

 

 

 

Engine is locked, will not pull over.

Engine problem.

Contact your nearest engine manufacturers

 

 

 

servicing dealer.

Self Propelled Units Only

 

 

 

 

 

 

 

No self-propelling

Transmission not in gear. Operator's bail not

Check transmission gear selection. Check clutch

 

engaging belt or out of adjustment. Worn out or

cable adjustment, belt and chain (See page 14).

 

broken chain. Broken or mispositioned belt.

 

 

 

 

 

 

Self propelled drive will not release

Sticking belt idler arm. Belt fingers bent or

Check idler. Idler arm mounting screw may be

 

broken.

too tight or too loose. Check belt guide.

 

 

Replace if broken.

 

 

 

 

Noisy or broken chain

No chain lubrication. Chain out of alignment or

See Chain Adjustments on page 14.

 

over tensioned.

 

 

22.1

Engine Service and Warranty

22

WARRANTY PROCEDURE

Contact your nearest engine manufacturer's

Should a Billy Goat Machine fail due to a defect in material and / or workmanship,

 

 

the owner should make a warranty claim as follows:

 

authorized servicing dealer.

 

21

Serial Plate

Record your machine model, serial number

and date-of-purchase and where purchased

 

 

 

1803 S. Jefferson

 

P.O. Box 308

 

Lee's Summit,

 

MO

64063 / USA

R

Tel (816) 524-9666

 

 

Fax (816) 524-6983

ModelSerial No.

115 dB

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Unit(Weight)

 

 

 

 

Engine Power

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Unit

 

 

kg

 

 

kW

 

 

rpm

 

 

 

lbs.

 

 

 

 

 

 

@

Purchase Purchased

Datefrom

-The Machine must be taken to the dealer from whom it was purchased or to an authorized Servicing Billy Goat Dealer.

-The owner must present the remaining half of the Warranty Registration Card, or, if this is not available, the invoice or receipt. -The Warranty Claim will be completed by the authorized Billy Goat Dealer and submitted to their respective Billy Goat Distributor for their territory. Attention: Service Manager. Any parts replaced under warranty must be tagged and retained for 90 days.

-The distributor service manager will sign off on the claim and submit it to Billy Goat for consideration.

-The Technical Service Department at Billy Goat will study the claim and may request parts to be returned for examination. Billy Goat will notify their conclusions to the distributor service manager from whom the claim was received.

-The decision by the Quality / Service department at Billy Goat to approve or reject a Warranty claim is final and binding.

Note: To process a Warranty Claim, it is necessary to quote the Model & Serial Number which are printed on the Billy Goat Serial Plate (See owner’s manual).

BILLY GOAT INDUSTRIES INC.

P.O. BOX 308, 1803 S JEFFERSON LEE'S SUMMIT, MO. 64082-2312 / USA PHONE: 816-524-9666 FAX: 816-524-6983 www.billygoat.com

Part No. 430149

Page 16 of 16

Form No. F121903A

Image 16
Contents Specifications Accessories7SOUND VibrationGeneral Safety Parts BAG & Literature Assy P/N Controls Exhaust door control Jam nut Stop switch bracket Handling & Transporting Blowing OperationStorage MPH KMH Drive Gear Selection @ 3600 RPMMachine Parked Parts Drawing Parts Drawing Switch Engine Assy Engine 16 HP VanguardGrill Scroll W. a Frame Front Wheel W.ASwitch Rocker Label OIL ChainLabel Shift Wheel Tire AssyLabel do not Fill When Engine is HOT Label Warning OpeiLabel Danger Flying Material Label EAR EYE BreathingReconnect Spark Plug Wire Guards Before Starting Engine Disconnect Spark Plug Wire Before Servicing UnitImpeller Removal Maintenance Chain tensioner bolt Jam nut Bearing Bolt Troubleshooting Warranty Procedure