17MAINTENANCE
Use only a qualified mechanic for any adjustments, disassembly or any kind of repair .
WARNING: TO AVOID PERSONAL INJURY, ALWAYS
TURN MACHINE OFF, MAKE SURE ALL MOVING
PARTS COME TO A COMPLETE STOP.
DISCONNECT SPARK PLUG WIRE
BEFORE SERVICING UNIT.
ENGINE: See engine manufacturer's service instructions.
REPLACE ALL GUARDS, BEFORE
STARTING ENGINE.
USE ONLY BILLY GOAT ORIGINAL
EQUIPMENT PARTS FOR
REPLACEMENT AND REPAIR
TINE ROW KIT 360197
Complete tine row set for replacement of one complete row of tines. Includes mounting plates, spacer, and all hardware.
TINE KIT 360100
Individual coring tine for replacement of worn or broken tines.
Spraying tines with a rust preventing lubricant can increase tine life and allow for easier replacement of worn or damaged tines.
TINE REEL REMOVAL AND TINE ROW REPLACEMENT
TINE REEL REMOVAL
NOTE: Tine reel removal is only necessary to replace an entire tine row or for other major unit maintenance. Individual tines can be replaced by following the TINE REPLACEMENT instruc- tions.
1.Wait for engine to cool and disconnect spark plug.
2.Remove the top guard by removing the four screws, two on each side, that secure it to the frame.
3.Release the tension on the chain. See CHAIN TENSION ADJUST- MENT in this manual.
4.Remove the four bolts and nuts, two on each side, holding the tine reel bearings in place. BE CAREFUL the tine reel is heavy and sharp. Take precautions to not allow it to fall when the bearing bolts are removed.
5.Lift the reel up and to the side to remove it from the drive chain.
6.See TINE ROW REPLACEMENT for instructions on maintenance.
7.To reinstall the reel follow the above steps in reverse.
8.Replace the guard and reinstall the four screws that secure it in place.
TINE ROW REPLACEMENT
1.Wait for engine to cool and disconnect spark plug.
2.Remove the top guard by removing the four screws, two on each side, that secure it to the frame.
3.Remove the tine reel per the TINE REEL REMOVAL instructions.
4.Remove the nut at the end of the tine reel shaft that secures the tine rows in place.
5.Remove the tine rows and spacers as necessary to replace the defective part. Be sure to note the order in which the spacers were removed for later reassembly.
6.Reassemble the tine reel in the exact order that it was disas- sembled.
7.Tighten the nut that secures the tine rows and spacers on the shaft. Torque the nut to a minimum of 100 ft.lbs. Check that all of the tine rows are tight by attempting to move them by hand.
8.Reinstall the tine reel per the TINE REEL REMOVAL instructions above.
9.Re set the tension on the chain.
10.Replace the guard and reinstall the four screws that secure it in place.
REPLACING INDIVIDUAL TINES
1.Wait for engine to cool and disconnect spark plug.
2.Loosen but do not remove the outermost nut and carraige bolt that secure the damaged or worn tine.
3.Loosen and remove the innermost nut and carraige bolt that hold the tine in the reel.
4.Use a small prybar and push the tine plates apart slightly to slide out the tine to be replaced.
5.Slide the new tine in place and secure with the innermost nut and carraige bolt. Tighten completely.
6.Retighten the outermost nut and carraige bolt to completely secure the new tine.
7.Repeat as required to replace all damaged or worn tines.
NOTE: Tines are a normal wear item and should be inspected regularly for signs of wear or damage.
Part No. 360178 | Page 10 of 12 | Form No. F121203A |