Setting up sources
31
Configuring the CD
player
This section explains how to use Gain mode to set up the analogue sources connected to the CD player.
To turn on Gain mode
•Put the CD player into standby by pressing Off (front panel or remote).
•Press and hold the Volume V key under the front panel for at least five
seconds.
The display shows: | Gain On |
|
|
The CD player will then return to standby with Gain mode turned on.
Gain mode adds an extra Sensitivity option to the menus.
To turn off Gain mode
•Repeat the above procedure.
The display shows: | Gain Off |
|
|
To adjust the sensitivity of a source
To obtain the best
•Turn on Gain mode, as described above.
•Select the source you want to adjust, with loud source material playing.
•Press < or > (remote) until the display shows the current sensitivity.
For example: | Radio 2.0V In |
•Press A or V (remote) to change the sensitivity.
You can select between sensitivities of 0.5V (most sensitive), 1.0V, 2.0V, or 2.5V (least sensitive).
If the sensitivity is set too high the input will clip the loudest passages. The display shows:
For example: Radio 0.5V In Clip
In this case reduce the sensitivity.
If you have selected a digital source you cannot adjust the sensitivity. The display shows:
For example: | CD | Not Analogue |