Cal Spas LTR20091002 Periodic Reminder Messages, Message Frequency Action Required RPH, Rsa, Rcl

Periodic Reminder Messages

Press the “Mode” button to reset a displayed reminder.

Message	Frequency	Action Required
rPH	Every 7 days	Test and adjust chemical levels per manufacturer’s instructions.
rSA	Every 7 days	Test and adjust chemical levels per manufacturer’s instructions.
rCL	Every 30 days	Remove, clean, and reinstall filter per manufacturer’s instructions.
rtg	Every 30 days	Test and reset GFCI per manufacturer’s instructions. Drain and refill
		spa per manufacturer’s instructions.
rdr	Every 90 days	Drain and refill spa per manufacturer’s instructions.
rCO	Every 180 days	Clean and condition spa cover
rCH	Every 365 days	Install New Bio-Clean™ Filter

Your new Cal Spa comes equipped with an electric heater. Following the directions listed below will ensure the most efficient operation:

NOTE: This method is only for spa usage under two hours a week.

•Keep the spa’s operating temperature 5˚ F below the desired usage temperature when not in use. One or two hours before use, set the temperature to the desired temperature.

•If the spa usage exceeds two hours a week, the set temperature should remain at the desired usage temperature.

•The air venturis should be used sparingly. When open, water temperature drops quite rapidly and can also dissipate chemicals.

Allowing the water temperature to lower more than 10˚F below the desired usage temperature and reheating it prior to usage will cause the heater to operate longer than it normally would maintaining the desired tem- perature. Doing this will increase your operating cost and makes your heater work more than necessary.

2009 Inground Spas

19 OperatingYour

Spa

LTR20091002, Rev. B www.calspas.com