Filter Cleaning
The filter is the part of your spa that removes the debris from the water and needs to be cleaned on a regular basis to maximize your spa’s filtering performance and heating efficiency.
In addition to spraying off the filter weekly to remove surface debris, your filter should be deep cleaned pe- riodically to dissolve scale and particles that get lodged deep within the filter fibers and impede the filtration process. Even if the filter looks clean, scale and particles can clog the fibers and prevent water from flowing through the filter resulting in the most common spa
We recommend you clean your filter once a month and replace it once a year or as necessary.
1.Remove the filter by turning it counterclockwise, unscrewing the bottom threads, then pulling it up and out.
2.Place the dirty filter into a bucket of water deep enough to cover the filter. Add 8 oz of Cal Spas “Liquid
Filter Cleaner” to the bucket of water.
Note: It is a good idea to keep a spare filter to use in the spa while the dirty filter is being deep cleaned. This way, you can rotate the filters and both will last longer.
3.Twist off the tablet tube and set it aside
4.Soak the filter for a minimum of 24 hours.
5.Spray the filter with a water hose. Spray each pleat carefully.
6.Put fresh bromine in the tablet tube (if you use it as a sanitizer) and twist it back on top of the filter.
7.Reinstall the filter. Do not overtighten.
27
Clear Water Plan
Bather Load
“Bather Load” is the term used to describe the num- ber of people using a spa, combined with the length of usage, and the frequency of usage. All these fac- tors have a great effect on the spa water. The higher the bather load, the more chemicals need to be add- ed and a longer filtration time will be needed.
All versions of the Cal Spas Clear Water Plan are designed for spas with average bather load (3 to
4 people, 15 minutes of usage, three times a week at 100 degrees) If your bather load exceeds these guidelines, and you experience water quality prob- lems, increase the amount of filtration first, (go to the next higher filtration number) then if water quality is still not adequate, consult the advice of your Cal Spas dealer for additional chemical or system recom- mendations. Be sure to give them your bather load information.
2009 Inground Spas
LTR20091002, Rev. B | www.calspas.com |