Exmark Lazer ZXS manual Evaporative Emission Control Warranty Statement

Page 39

10.Evaporative Emission Control Warranty Statement

California Evaporative Emission Control Warranty Statement

Your Warranty Rights and Obligations

Introduction

The California Air Resources Board and Exmark Manufacturing Company are pleased to explain the evaporative emission control system’s warranty on your 2006 model year equipment. In California, new equipment that uses small off-road engines must be designed, built, and equipped to meet the State’s stringent anti-smog standards. Exmark Manufacturing Company must warrant the evaporative emission control system on your equipment for two years provided there has been no abuse, neglect or improper maintenance of your equipment.

Your evaporative emission control system may include parts such as: fuel lines, fuel line fittings, and clamps.

Manufacturer’s Warranty Coverage:

This evaporative emission control system is warranted for two years. If any evaporative emission-related part on your equipment is defective, the part will be repaired or replaced by Exmark Manufacturing Company.

Owner’s Warranty Responsibilities:

ƒAs the equipment owner, you are responsible for performance of the required maintenance listed in your Operator’s Manual. Exmark Manufacturing Company recommends that you retain all receipts covering maintenance on your equipment, but Exmark Manufacturing Company cannot deny warranty solely for the lack of receipts.

ƒAs the equipment owner, you should however be aware that Exmark Manufacturing Company may deny you warranty coverage if your emission warranty parts have failed due to abuse, neglect, or improper maintenance or unapproved modifications.

ƒYou are responsible for presenting your equipment to an Authorized Service Dealer as soon as the problem exists. The warranty repairs should be completed in a reasonable amount of time, not to exceed 30 days. If you have a question regarding your warranty coverage, you should contact Exmark Manufacturing Company at 1-402-223-6375.

Defects Warranty Requirements:

1.The warranty period begins on the date the engine or equipment is delivered to an ultimate purchaser.

2.General Evaporative Emissions Warranty Coverage. The emission warranty parts must be warranted to the ultimate purchaser and any subsequent owner that the evaporative emission control system when installed was:

A.Designed, built, and equipped so as to conform with all applicable regulations; and

B.Free from defects in materials and workmanship that causes the failure of a warranted part for a period of two years.

3.The warranty on evaporative emissions-related parts will be interpreted as follows:

A.Any warranted part that is not scheduled for replacement as required maintenance in the written instructions must be warranted for the warranty period of two years. If any such part fails during the period of warranty coverage, it must be repaired or replaced by Exmark Manufacturing Company. Any such part repaired or replaced under the warranty must be warranted for a time not less than the remaining warranty period.

B.Any warranted part that is scheduled only for regular inspection in the written instructions must be warranted for the warranty period of two years. A statement in such written instructions to the effect of “repair or replace as necessary” will not reduce the period of warranty coverage. Any such part repaired or replaced under warranty must be warranted for a time not less than the remaining warranty period.

C.Any warranted part that is scheduled for replacement as required maintenance in the written instructions must be warranted for the period of time prior to the first scheduled replacement point for that part. If the part fails prior to the first scheduled replacement, the part must be repaired or replaced by Exmark Manufacturing Company. Any such part repaired or replaced under warranty must be warranted for a time not less than the remainder of the period prior to the first scheduled replacement point for the part.

D.Repair or replacement of any warranted part under the warranty provisions of this article must be performed at no charge to the owner at an Authorized Service Dealer.

E.Notwithstanding the provisions of subsection (D) above, warranty services or repairs must be provided at an Authorized Service Dealer.

F.The owner must not be charged for diagnostic labor that leads to the determination that a warranted part is in fact defective, provided that such diagnostic work is performed at an Authorized Service Dealer.

G.Throughout the evaporative emission control system's two year warranty period, Exmark Manufacturing Company must maintain a supply of warranted parts sufficient to meet the expected demand for such parts.

H.Manufacturer approved replacement parts must be used in the performance of any warranty maintenance or repairs and must be provided without charge to the owner. Such use will not reduce the warranty obligations of Exmark Manufacturing Company.

I.The use of any add-on or modified parts will be grounds for disallowing a warranty claim made in accordance with this article. Exmark Manufacturing Company will not be liable under this Article to warrant failures of warranted parts caused by the use of an add-on or modified part.

J.Exmark Manufacturing Company shall provide any documents that describe the warranty procedures or policies within five working days of request by the Air Resources Board.

Emission Warranty Parts List:

The following list includes the parts covered under this warranty:

Fuel Lines

Fuel Line Fittings

Clamps

- 34 -

Image 39
Contents For Serial Nos 600,000 & Higher Potential Hazard Exmark Parts PLUS→ Program Operators Manual Table of Contents Training SafetySafety Alert Symbol Your Safety is InvolvedCarbon monoxide can kill you Operation Potential Hazard Page Maintenance and Storage Safety SignsRiding Attachments Location 32 & 36 Decks Under Page Specifications Controls DimensionsOperation Instructions Torque RequirementsPistol Grip Handle Neutral LOCK/PARK Brake Latch ECS Handle PRE-START Operating Instructions Drive LEVER, Neutral LOCK/PARK Brake Operation Drive LEVER, Neutral LOCK/PARK Brake Latch Operation Transporting Periodic Maintenance Maintenance and AdjustmentsBlade Bolt Installation Service Interval DailyPistol Grip Handles Drive Lever Hardware Location For Pistol Grip HandlesPistol Grip Handles Neutral Lock Lever Clearance ECS Handle Drive Lever SettingECS Handle Drive Lever Linkage Installation Service Interval 160 hrs Service Interval 40 hrsService Interval Refer to Chart Lubrication Chart Spray Lubricant ChartService Interval As Required Adjustments Caster Height Adjustment Cutting Height Adjustment 1 to 4 1/4 Mower Deck Belt Adjustment Blade Brake Adjustment Shifter Lever To Transmission Waste Disposal Trouble ShootingEngine will not Start Engine TroubleshootingBlades do not Stop When Disengaged Mower Cuts UnevenlyWiring Diagram Engine Troubleshooting TableMower Deck Belt Routing For units purchased on or after October 1 Year Limited Warranty Exmark Turf EquipmentEvaporative Emission Control Warranty Statement Page Page Date Description of Work Done Service RecordFold Along Appropriate Line Check us out on the Web See EXMARK’S Complete Line of Accessories