Setup
Setup
Installing OCD02 on Mower Deck
Important: For Serial Numbers 790,000 and higher, multiple accessories added to a base unit can change the stability of the machine. Read the unit operator’s manual to determine if counterbalance weights are necessary for the accessories installed on the unit.
1.Remove the floorpan.
2.Remove the discharge deflector from the deck.
3.Remove the bracket from the discharge deflector and retain the hardware.
4.Use the template provided as a guide to cut off the lip of the discharge deflector. Fold the template and align the three slots on the template with the discharge deflector as shown in Figure 2. Cut along the bottom portion and the outer edges on each side of template to remove the lip.
Figure 2
1. | Discharge deflector | 3. | Cut along template |
2. | Template | 4. | Lip removed |
Figure 3
1. | Foot pedal | 3. | Toe board |
2. | 4. | ||
| carriage bolt |
|
|
7.Install the cable bracket on the frame rail and position close to foot pedal as shown Figure 4. Secure the bracket with
5.Reassemble the bracket, that was removed in step 3, into the discharge deflector and fasten with its hardware.
6.Install the foot pedal onto the toe board as shown in Figure 3.
Figure 4
1. | Nyloc nut | 5. | Foot pedal |
2. | Cable bracket | 6. | Cotter pin |
3. | 7. | Bolt and nut adjustment | |
| carriage bolt |
|
|
4. | Cable | 8. | Cable nut |
8.Hook the end of the cable onto the foot pedal and insert the cotter pin.
8