Exmark MPKA21 manual Using the Grass Bag

Operation

WARNING

Adjusting the cutting height levers could bring your hands into contact with a moving blade. A moving blade can cause serious injury.

•Stop the engine and wait for all movement to stop before adjusting the cutting height.

•Do Not put your fingers under the housing when adjusting the cutting height.

1.Pull the wheel height adjustment lever toward the wheel (Figure 13) and move it to the desired setting.

Figure 13

1. Pull towards wheel 3. Notches

2.Wheel Height Adjustment Lever

2.Release the wheel height adjustment lever and set it securely in the notch.

3.Adjust all the wheels to the same cutting height setting.

Using the Grass Bag

Occasionally, you may wish to use the grass bag for bagging extra long grass, lush grass, or leaves.

•Installing the Grass Bag

1.Stop the engine and wait for all moving parts to stop.

2.Ensure that the discharge door handle is fully forward and that the pin is engaged in the catch (Figure 14).

Figure 14

1. Bag Frame on retaining	3. Handle fully
post.	forward—discharge
	door closed.

2.Pin engaged in catch.

3.Slide the hole in the bag frame onto the retaining post on the discharge tunnel.

4.Set the rear of the bag frame onto the bag support rod.

5.Pull the discharge door handle forward until the pin clears the catch, and move the handle rearward until the pin locks in the bag notch (Figure 15).

Figure 15

1.Pin locked in bag notch.

Note: The discharge door in the lawn mower housing is now open.

20