Adjusting the Anti-Scalp Rollers

Operation

A. The front and rear hairpins are in the same holes with the proper spacers under the hair pins. See Figure 5.

Figure 6

Figure 5

Left Hand Side Shown

1. Deck support pin

Cutting Height

B.The tire pressures are set as directed in Check Tire Pressures in the Maintenance section.

C.The length of the rear deck support link assemblies average 6.89 inches (approximately 6 7/8 inches) (175.01 mm) from the center of the balljoint to the center of the farthest hole. See Figure 6.

Note: All four pins must equally support the weight of the deck. Adjustment in the length of the rear deck support assemblies may be necessary. If one side is longer than 6.89 inches (approximately 6 7/8 inches) (175.01 mm), than the opposite side must be shorter by the same amount.

It is recommended to change the anti-scalp roller position, when the height of cut has changed.

1.Stop the machine and move the drive levers to the neutral locked position.

2.Disengage the PTO.

3.Engage the park brake.

4.Stop the engine, remove the key and wait for all moving parts to stop.

5.After adjusting the height of cut, adjust the anti-scalp rollers by removing the spring disc washer and bolt (see step 7).

6.Adjust anti-scalp rollers for Normal Operating Conditions. Place rollers in one of the positions shown in Figure 7. Rollers will maintain 3/4 inches (19 mm) clearance to the ground to minimize gouging and roller wear or damage.

Note: For Maximum Deck Flotation, place rollers one hole position lower. Rollers should maintain 1/4 inch (6.4 mm) clearance to ground. Do Not adjust rollers to support the deck. Be sure roller bolts are installed with the spring disc washer between head of the bolt and mounting bracket.