Operation
Operation
Note: Determine the left and right sides of the machine from the normal operating position.
Controls
Operator Presence Control (OPC) Levers
Located on the upper handle assembly directly above the handle grips.
When these levers are depressed, the OPC system senses that the operator is in the normal operator’s position. When the levers are released, the OPC system senses that the operator has moved from the normal operating position and will kill the engine if either the speed control lever is not in the neutral position or the PTO is engaged.
lever is moved out of the neutral position and the neutral lock latches are moved into the drive position, as shown in Figure 4, and the drive levers are released, the drive wheels are engaged in the forward direction.
Squeezing the left hand and/or right hand lever causes the left hand and/or right hand drive wheel respectively to slow down, stop, or reverse, depending on how far each drive lever is “squeezed”. Squeezing the drive levers beyond the neutral position causes the drive wheels to engage in the reverse direction regardless of the position of the neutral lock latches and the speed control lever.
Neutral Lock Latches
Located directly above the drive levers.
These latches allow the operator to lock the drive levers in a “neutral” position where the drive wheels are not engaged in either a forward or reverse direction, see Figure 4.
Figure 4
1. | Latch is in the drive | 5. | |
| position |
| position |
2. | Rotate back for neutral | 6. | |
| lock position |
| lever |
3. | Neutral | 7. | |
|
|
| lever |
4.Full speed forward
Drive Levers
Located on each side of the upper handle assembly directly below the handle grips.
These levers individually control the speed and direction of each drive wheel. When the speed control
Choke Control
Located on the control console right hand side.
Choke is used to aid in starting a cold engine. The choke control is pulled out to be in the “ON” position and pushed in to be in the “OFF” position. Do Not run a warm engine with choke in the “ON” position.
Throttle Control
Located on the control console’s right side.
The throttle is used to control engine speed. Moving the throttle control forward will increase engine speed and moving it to the rear will decrease engine speed.
Speed Control Lever
Located in middle of control console.
The speed control lever controls the maximum forward speed and is infinitely variable from neutral
Park brake must be disengaged to move speed control out of neutral or engine will kill.
Brake Lever
Located on the left side of the unit above the hydraulic tank.
15