Ferris Industries 1000z Series manual TRIPLE-BAG Collection System Blower Mount & Drive Group

Initial

Installation & Assembly

61” TRIPLE-BAG COLLECTION SYSTEM

BLOWER MOUNT & DRIVE GROUP

Remove Discharge Chute

1. Park machine on a flat, level surface and apply the parking brake.

2. Remove the discharge chute and save. Save springs and spacer (Derby Stallion only).

Figure 19. Chute Removal

Release Mower Drive Belt Tension

1.Raise the floor pan and loosen the spring compres- sion nut (A, Figure 20) to release the belt tension.

B

A

Remove Guard & Spindle Pulley

1.Remove the right-hand belt guard (A, Figure 21) and save. Remove and discard the two front 5/16-18 x 1” bolts (G), 5/16” washers (F) and 5/16” body clips.

2.Remove the mower deck drive belt from the right- hand spindle pulley.

3.Remove the right-hand spindle pulley (D), 5/8”: nylon lock nut (B), 5/8” washer (C) and 1/4” key (E). Use a block of wood to keep the blade from spinning while removing the 5/8” nut.

Figure 20. PTO Mower Drive Belt

A.Spring Compression Nut

B.Idler Spring

A
	B
	C
	D
G	F
	E

Figure 21. Belt Guard & Pulley Removal

A.	Guard	E.	Key
B.	5/8” Nylon Lock Nut	F.	5/16” Washer (3)
C.	5/8” Washer	G.	5/16-18 x 1” Bolt (3)

D.Spindle Pulley

10