48” & 52” Blower Mount & Drive Installation
2.While holding the mount plate vertical and against the chute mount tabs, place the spacers on the mower deck in the recesses of the mount plate. Make sure they are at the bottom of the recess (see
Figure 7). Mark their location with a paint pen or prick punch.
3.Remove the spacers and blower mount plate.
4.Drill 5/16” holes where the spacer location was marked.
Figure 7. Spacer Location
5.Install the spacers (C, FIgure 8) and mount bar (B) on the mower deck and secure with the
A | B |
| |
C |
|
| D |
Figure 8. Install Quick Connect Bar
A. | 5/16” Nylon Lock Nut (2) | C. | Spacer (2) |
B. | Quick Connect Bar | D. | 5/16” x |
6