
61” Blower Mount & Drive Installation
11.Loosely install the blower brace (A, Figure 28), 3/8- 16 x 1” bolts (B) and 3/8” washers (C) as shown. These fasteners will be tightened in a later step.
12.Install the blower pulley and key with the hub facing OUTWARD away from the bearing and hold against the bearing. Tighten set screws.
13.Install one
14.Loosen the idler pulleys and install the belt under the belt keeps. Make sure the groove of the belt is prop- erly seated in the
| B |
| A |
B | C |
| |
C |
|
Figure 28. Install Blower Brace
A.Blower Brace
B.
C.3/8” Washer
Figure 29. Install Blower Pulley & Guide Bolt
Figure 30. Belt Routing
14