Ferris Industries 1000z Series, IS3000z Series manual Blower Mount & Drive Installation

Page 14

61” Blower Mount & Drive Installation

Blower Preparation

1.Remove the belt guard (A, Figure 24) and hardware (B & C) from the blower housing and set aside.

NOTE: Record the model and serial number of the blower on the warranty registration card and in the space provided on Page 1. The serial tag is located on the outside face of the blower housing.

2.Fasten the idler arm assembly (G) to the blower housing with 5/16-18 x 1-3/4” bolt (D), 5/16” fender washer (E), pivot spacer (F) and 5/16-18 serrated flange nut (H). Tighten securely.

3.Remove the top stationary idler pulley (I) and replace in the middle hole of the inside row of holes. Tighten securely.

3.Remove the two 7/16” bolts and hex nuts from the inside bearing. Remove the bearing from the blower housing and discard the two hex nuts.

4.Install the blower mount plate (A, Figure 25) onto the back plate of the blower. Install the four 5/16-18 x 3/4” self-tapping bolts (B), but do not tighten until all screws have been started. Tighten securely.

5.Install two 5/16” x 3/4” bolts (C) near the bearing. Secure with the 5/16” nylon lock nuts (D) as shown.

A

B

C

D

E

I

F

G

H

Figure 24. Idler Arm Installation

A.

Belt Guard

F.

Pivot Spacer

B.

5/16-18 x 1” Bolt

G.

Idler Arm Assembly

C.

5/16” Washer

H.

5/16-18 Flange Nut

D.

5/16-18 x 1-3/4” Bolt

I.

Idler Pulley

E.5/16” Fender Washer

C

A

B

D

B

Figure 25. Install Blower Mount Plate

A.Mount Plate

B.5/16-18 x 3/4” Self-Tapping Bolts

C.5/16-18 x 3/4” Bolts

D.5/16-18 Nylon Lock Nuts

12

Image 14
Contents OPERATOR’S Manual Triple Bag Collection System forFerris Limited Warranty Table of Contents Safety Rules Information General Operating Instructions Remove Guard & Spindle Pulley Remove Discharge ChuteRelease Mower Drive Belt Tension Mower Deck Preparation Install Spindle PulleyInstall Guard 48 & 52 Blower Mount & Drive Installation Idler Arm Installation Blower PreparationInstall Bearing & Eyebolt Install Blower & Belt Guard Install Blower & Belt GuardTRIPLE-BAG Collection System Blower Mount & Drive Group Blower Mount & Drive Installation Install Guard & Blower MountBlower Mount & Drive Installation Install Bearing & Spring Install Blower Brace Install Blower Discharge Chute Reattachment Reattaching the Discharge ChuteHardware Identification & Torque Specifications