Hayter Mowers RZT420H manual Setup, Setting Up the Motion Control Levers, Loose Parts

Setup

Loose Parts

Use the chart below to verify that all parts have been shipped.

Procedure	Description	Qty.	Use
1	No parts required	–	Set up the motion control levers.
2	Clevis pin	1	Install the seat cable.
	Hair Pin	1
3	No parts required	–	Connect the battery.
4	Ignition Key	1
	Operator’s Manual	1	Complete the Setup.
	Engine Operator’s Manual	1

Note: Determine the left and right sides of the machine from the normal operating position.

1

Setting Up the Motion Control Levers

No Parts Required

Procedure

1.Remove the upper bolt (3/8 x 1 inch) and washer; loosen the lower bolt (3/8 x 1 inch) as shown in Figure 3. Raise the motion control levers.

2.Align the holes in the motion control lever with the holes in the control arm shaft and install the bolt and washer removed previously (Figure 3). Hand tighten all fasteners. Repeat this for both controls levers.

Figure 3

10