OPERATING THE MOWER
Side Discharge 
Remove the rear discharge chute by removing nuts and washers.
Slide the assembly from under the the shoulder bolt (A).
Slide the new side dicharge chute assembly under the shoulder bolt
(A). Then fasten the front and the back of the assembly with the fas- | A |
| |
teners. |
|
A
Heavy Growth
To prevent engine overloading and blockages be prepared to make two cuts in areas of heavy growth. If collection is required, first mow the area at the maximum height of cut setting with the grassbag fitted. Reduce the height of cut and mow the area again as necessary until the required finish is obtained.
To prevent grass damage do not remove more than one third of grass height in one cut.
Non-Grassed Areas
When moving the mower across
1.14