ASSEMBLING THE MOWER
Delivery Checklist
Remove the mower from the packaging and check that the following items have been supplied correctly. If any items are missing contact, your local Hayter dealer.
1. | Engine Handbook. | 4. | Mulcher Plug Note.(Inside Chute) |
2. Warranty Reg. Card. | 5. | Side Discharge Chute | |
3. | Grassbag. |
|
|
To prevent accidents cut off the long ribbon attached to the grass- bag and discard.
Handlebar |
Double3
Unscrew the handlebar securing knobs sufficiently to allow the handle- bar to pivot. Unfold the handlebar to the operating position. Tighten both handlebar knobs to secure the handlebar in position.
Take care to ensure that the control cables do not become snagged at the pivot point.
Adjust Handlebar Height
Remove the ‘R’ Clip. Locate the pin in one of the three holes in the adjuster strap for best position and comfort. Ensure both sides are set to the same height. Secure in the required position with the ‘R’ Clips.
Grassbag Attachment
The mower is shipped with a ‘Mulcher Plug’ fitted inside the dis- charge chute. Open the rear door and remove prior to initial use.
To attach the grassbag, Open the rear door and lower the grassbag through the handlebar making sure the top corners of the grasbag frame hook over the rear plate and into position.
1.9