Assembling and Hanging the Fan | Hunter Fan 42027-01 instruction

3 • Assembling and Hanging the Fan

	Standard	Label
	Mounting	Label
	Mounting
	Washer
	Step 3-1	Canopy
	Step 3-1

Do not remove the protective wrap

from the silhouette on the motor

6housing. You will remove it after the last step on page 13.

Steps 3-2 – 3-4

Downrod

Canopy

(with Washer)

Canopy

Trim Ring

Adapter	Set Screw

You can assemble your fan for standard or angle mounting as shown in steps 3-1 – 3-6. For low profile mounting (ceilings less than 8 feet high), go to steps 3-7 – 3-11 on the next page.

3-1. Remove the label from the standard mounting washer inside the canopy. Leave the washer in place. (Note: You will not use the washer included in the parts sack.)

3-2. To assemble fan to hang down from a flat or angled ceiling, place the canopy with washer, and canopy trim ring around the adapter so that they rest on the fan assembly.

3-3. Feed the wires from the fan through the downrod.

3-4. Using the provided allen wrench, loosen the allen head set screw on the adapter to install the pipe and ball assembly. Note: When the pipe and ball assembly is fully installed, 2-3 threads on the pipe will still be visible; this is normal. Securely retighten the set screw with the allen wrench.

CAUTION: e adapter has a special coating on the threads. Do not remove this coating; the coating prevents the downrod from unscrewing. Once assembled, do not remove the downrod.

WARNING: Do not carry or lift fan by canopy.

3-5. Raise the fan and place the ball into the hanger bracket.

3-6. Align the notch on the ball with the indent in the hanger bracket. (Rotate the fan until you hear the notch pop into place.)

Go to 4 • Wiring the Fan.

WARNING: Fan may fall if not assembled as directed in these installation instructions.

Steps 3-5 – 3-6	Indent

Hunter Fan Company

42027-01 • 12/09/05