Hunter Fan 22360 warranty Pre-Installation, Pre- Installation

Page 5

Pre-Installation

Pre- Installation

Select installation site: Normally this is near the center of the room, often replacing a light fixture. Make certain that ample clearance is left for the rotating fan blades. For maximum efficiency, no obstruction (walls, posts, etc.) should be within 24” of the tips of the blades (see Fig. 1).

Your Hunter fan comes with the proper hardware to hang the fan from a 9 foot ceiling so the fan blades will be 17 1/4” from the ceiling and approximately 7 feet from the floor (see Fig. 1).

NOTE: On vaulted ceilings, up to 45° pitch, you may want to use the Hunter Vaulted Ceiling Mounting Kit (22174). This kit can be purchased via our website or our parts and service number provided on page 15 of this manual.

! CAUTION !

NEVER LIFT THE MOTOR BY THE WIRES.

LET MOTOR REST IN THE CARTON LINER FOR PROTECTION.

5

17 1/4” (ref.) Minimum

24” Clearance

7’ From Floor

Fig. 1

Hunter Fan Company

42704-01 • 01/29/07

Image 5
Contents For Your Records and Warranty Assistance Read and Save These Instructions WelcomeConsidering Optional Accessories Optional AccessoriesUnderstanding Mounting Standard MountingGathering the Tools Getting ReadyChecking Your Fan Parts Preparing the Fan SitePre- Installation Pre-InstallationDo not USE Lubricant on Screws Installing Ceiling HardwareHanging The Fan Rubber Bushing Hanger Pin Bracket Dual Switch Wiring see Fig Wiring the FanInstalling The Canopy Adding Oil LubricationChecking Oil Your Original Hunter’s Unique Lubricating SystemInstallation Of Fan Blade Assembly Fan Blade AssemblyInstalling Bulb And Globe To Reverse The Flow Of Air Operation And CareProblem Nothing happens fan does not move Troubleshooting GuideProblem Noisy operation Problem Excessive wobblingHunter Fan Company Hunter FAN CO