Hanging The Fan
5.Back out the set screw on the hanger bracket.
6.Feed the 3 wires through the hanger bracket assembly and screw the hanger bracket onto the hanger pipe until tight (at least 3 turns) (see Fig, 6).
7.Use pliers to tighten both the hanger bracket assembly and the hanger pipe together.
8.Tighten the set screw in the motor housing and the hanger bracket assembly (see Fig 7).
Hanger
BracketHanger
Bracket
Set Screw
Hanger
Pipe
Motor Housing
Set Screw
8
Fig. 6 | Fig. 7 |
9.Be sure that the pin is centered in the rubber bushing.
10.Lift the fan by the motor housing, hook the hanger bracket assembly onto the rubber bushing and pin. Make sure both ends of the pin are outside the hanger bracket assembly (see Fig 8).
Rubber |
|
Bushing | Hanger |
and Pin | |
| Bracket |
| Assembly |
Fig. 8
Hunter Fan Company |