Hanging The Fan
! CAUTION !
BE SURE TO TIGHTEN THE HANGER PIPE INTO THE FAN, AND THE
HANGER BRACKET ONTO THE PIPE. TIGHTEN THE 2 SET SCREWS, AS
DESCRIBED IN STEP 7, TO PREVENT THE FAN FROM FALLING. YOUR FAN
MAY WEIGH UP TO 50 LBS. ALL OF THE FOLLOWING STEPS MUST BE
FOLLOWED IN ORDER TO ENSURE A SECURE MOUNTING.
1.Feed the wires from the top of your motor through the hanger pipe (see Fig. 3).
2.Back out the motor housing set screw (Do not completely remove from fan) in neck of fan motor housing and hanger bracket assembly so the hanger pipe can be screwed in.
3.Screw the pipe into the fan until tight (at least 4 1/2 turns) (see Fig. 4).
NOTE: Some of the pipe threads may still be visible.
4.Slide the canopy down over the hanging pipe (see Fig. 5). Wires 
Hanger | 7 |
Pipe |
Motor Housing
MotorSet Screw
Housing
Fig. 3 | Fig. 4 |
Canopy
Fig. 5
Hunter Fan Company |