325 LX Clean Sweep Assembly
2
Secure the drum axle to the shaft
| Clevis Pin |
|
| Hitch |
|
| Pin | Install drum |
27033 | 1 | |
Drum Axle |
| axle onto |
| output shaft | |
Cotter Pin |
|
|
| 4 |
|
| Secure |
|
| with a |
|
| cotter pin |
|
Drum 
Assembly
3
Install the sweeper drum assembly
1.Push one of the drum axles onto either of the two gearcase output shafts. If necessary, rotate the drum axle until the clevis pin hole in the axle aligns with the matching hole in the gearcase output shaft.
2.Use a clevis pin and hitch pin to secure the drum axle to the shaft.
3.Slide the recessed end of a sweeper drum assembly over the assembled axle, and then push the drum down the axle until it bottoms at the clevis pin.
4.Use a cotter pin to secure the drum assembly on the axle (see inset). The cotter pin is designed to fit tightly against the outboard end of the drum, so you may need to compress the drum face slightly during installation.
5.Repeat Steps
CAUTION!
The two drum assemblies are identical, but each drum must be installed with its recessed end facing toward the gearcase.
2