Cuisinart DLC-5 manual Assembly Instructions, Operating Controls

ASSEMBLY

INSTRUCTIONS

Read all instructions before you start. Check that your household voltage matches that shown on label on bottom of food processor base.

Blade Operation

1.Put base on counter or table near electrical outlet. Do not plug in until food processor is totally assembled. Pick up empty work bowl, holding it in both hands, with handle toward you. Put bowl on base, fitting center tube over shaft on base and placing handle slightly to left of front center (7 o’clock).

2.Turn bowl counterclockwise as far as it will go. It will click into locked position.

3.Pick up metal blade by center plastic part. Never touch metal cutting blades, which are razor sharp. Note D-shaped outline on top; it matches shape of motor shaft.

4.Place blade over motor shaft, lining up D-shaped outline with shape of shaft. Blade should drop onto shaft. If it doesn’t, twist it gently clockwise until it does. Push top of center plastic part to push blade down as far as it will go. Lower blade should almost touch bottom of bowl.

5.Put cover on bowl, with feed tube at front, slightly to left of front center.

6.Turn cover counterclockwise to lock it into place. It will click into position. Motor will not start unless work bowl is securely locked in position and cover is securely locked on work bowl.

7.Insert pusher in feed tube. Always use pusher to guide food through feed tube. Never use your fingers or spatula.

8.Plug your Cuisinart® Food Processor into a household electrical outlet.

Disc Operation

1.Assemble bowl on base in usual way (see steps 1 and 2 above.)

2.Always handle slicing or shredding disc by rims. Never touch sharp cutting blades. Note D-shaped cutout on top of disc. It matches shape of motor shaft.

Place disc over motor shaft, lining up D-shaped cutout over shaft. Disc will drop onto shaft.

3.Be sure disc is pushed down as far as it will go. Push only on rim; never touch sharp cutting blade.

4.Put cover on work bowl and turn it counterclockwise to lock it into place.

5.Put food into feed tube. (If you are slicing, first cut one end of food flat.)

6.Insert pusher. Use moderate pressure to push down on pusher with one hand while holding control switch down with other hand until food is sliced or shredded. This will take only a few seconds.

Never put fingers or spatula in feed tube. Always use pusher.

Wait until disc stops spinning before removing cover. When it stops, remove cover before removing work bowl. Never try to remove cover and work bowl together; this could damage work bowl.

Remove disc before removing work bowl. Place two fingers under each side of disc and lift it straight up.

Then turn bowl clockwise to remove it from base and lift it straight up.

OPERATING CONTROLS

Control switch on base of machine has 3 posi- tions, giving you fingertip control of operation.

For continuous operation, move control switch up to ON position. Motor will start.

To turn motor off, move control switch down to OFF position in center.

For on-off operation, called pulse-chopping or pulsing, press control switch down to PULSE position, then release it.

Motor runs as long as you hold control switch down. Motor stops when you release control switch. Try it a few times.

Notice that you control duration and frequency of pulses by length of time you hold control switch down and rate at which you press it. Allow enough time between pulses to let everything in work bowl fall to bottom.

Always use control switch for pulse/chopping. Never turn cover back and forth to start and stop processor.

4