Cuisinart manual Safety, Repacking For Shipment, DLC-5 is intended for Household Use Only

The DLC-5 is intended for Household Use Only

SAFETY

•Like any powerful electrical appliance, your food processor should be handled with care. These are some procedures that will protect you and your family from misuse that could cause injury.

•Handle metal blade and discs carefully. Their cutting edges are very sharp.

•Never put blade or disc on motor shaft until work bowl is securely locked in place.

•Always make certain that blade or disc is down on motor shaft as far as it will go.

•Always insert metal blade in work bowl before putting ingredients in work bowl.

•When slicing or shredding food, always use pusher. Never put your fingers or a spatula into feed tube.

•Always wait for blade or disc to stop spinning before you remove cover from work bowl.

•Be careful not to let metal blade fall out of work bowl when you empty bowl. Remove it before tilting bowl, or hold it in place.

SOME TECHNICAL DATA

The line voltage and frequency appropriate for your machine are shown on label on underside of base.

A safety switch prevents machine from operat- ing when work bowl or cover is not locked into position. Motor stops within seconds when control switch is turned off or cover is unlocked.

An automatic temperature-controlled circuit breaker in the motor ensures protection against motor burnout. If processor runs for exception- ally long time when chopping, mixing or knead- ing thick or heavy mixtures in successive batches, motor may overheat. If this happens, processor will stop. Turn it off and wait for motor to cool off before proceeding. It will usu- ally cool off within 10 minutes. In extreme cases, it could take an hour.

If it does not start or stop, please call our Customer Service Department toll free at 800- 726-0190.

REPACKING

FOR SHIPMENT

Save the carton that your food processor was packed in, and the carton inserts too. They will be useful if you need to repack the processor for moving or other shipment.

1.Open 4 flaps at one end of carton. Insert plastic foam block with cut-out for processor base at closed end of carton.

2.Place carton on floor or low table.

3.Place work bowl on base of machine and lock it into place. Coil power cord and secure it with rubber band or twist tie. Make sure work bowl is still locked into place.

4.Lift base by grasping top of work bowl with both hands. Lower it into box, positioning it so control switch and power cord fit into appropriate cutouts of foam block.

5.Insert metal blade on motor shaft.

6.Place second foam block into carton, posi- tioning it so short side with cavity for work bowl cover goes over handle side of work bowl.

7.Slide slicing and shredding discs into slots provided on opposite long sides of foam block. BE CAREFUL NOT TO TOUCH CUTTING EDGES.

8.Insert spatula, round side up, into space provided on one long side of foam block.

9.Insert work bowl cover, upside down, into large cavity of foam block.

10.Insert pusher into feed tube of workbowl.

11.Close flaps and tape all seams securely with pressure-sensitive or other packing tape. If you are shipping by public carrier, wrap carton in heavy paper, tape or tie it and address it. The Cuisinart Customer Service Department will give you complete shipping instructions if you are returning processor for repair.

12