Dell 2330dn service manual Guide. See Rear exit guide assembly with sensor

Error	Description	Action
201.25	Exit sensor never made by leading edge of media	Remove the toner cartridge/PC kit and check for
	when feeding out the media that was detected during	obstructions between the input sensor and the fuser.
	warm-up.	if the media continues to stop at the entrance or in
		the fuser, then replace the fuser. See “Fuser
201.26	Page at fuser nip before fuser started ramping toward	removal” on page 4-20.
	desired temperature. Indicates code may be receiving
	more interrupts than intended
201.27	Page at fuser nip before fuser reached acceptable
	operating temperature. Page arrived at fuser earlier
	than expected, so it was probably staged prematurely.
202.00	Paper jam around exit sensor.	Open the rear cover and look for obstructions in the
		path way. If there are none, then inspect for damage
		at the fuser, rear door, exit guide, and top cover.
		Often, the leading edge of the media will indicate the
		vacinity of damage. If damage is found, then replace
		the damaged part.
		Note: Print a page with the rear door open to isolate
		the fuser from the other parts.
202.01	Exit sensor never broke on the trailing edge of the	Open the rear door, and inspect the flag on the exit
	sheet at the exit sensor.	sensor. The flag is located behind the fuser exit
		rollers, about mid printer. If the flag does not rotate
202.02	Exit sensor never broke from sheet ahead of page	freely or has no spring action, then replace the fuser.
	heading toward the exit sensor.	See “Fuser removal” on page 4-20.
202.06	Exit sensor bounced
202.13	Exit sensor covered, media not expected (media not in
	machine during warm-up)
202.25	Exit sensor never broke from the sheet ahead of the
	page heading toward the exit sensor when feeding out
	the media detected during warm-up.
202.26	Trailing edge never cleared exit sensor when feeding	Open the rear door, and inspect the flag on the exit
	out media that was detected during warm-up.	sensor. The flag is located behind the fuser exit
		rollers, about mid printer. If the flag does not rotate
		freely or has no spring action, then replace the fuser.
		See “Fuser removal” on page 4-20.
202.32	Long media or shingled multi feed stopped before	Check the paper setting and correct if needed. While
	sending to duplex.	feeding along the media, and immediately after it
		enters the output bin, open the reat door and
		obscure the trailing edge and the sensor flag. If there
		is slippage in the exit guide, then replace the exit
		guide. See “Rear exit guide assembly with sensor
		and reversing solenoid removal” on page 4-48.

2-12