Husqvarna 346XP EPA II, 353 EPA I Throttle lock, Chain catcher, Right hand guard, Stop switch

Page 9

SAFETY INSTRUCTIONS

Grasp the chain saw ﬁrmly, wrapping your ﬁngers and thumbs around the handles.

Apply full throttle and activate the chain brake by tilting your left wrist forward onto the front hand guard. Do not let go of the front handle. The chain should stop immediately.

Throttle lock

•Make sure the throttle control is locked at the idle setting when the throttle lock is released.

•Press the throttle lock and make sure it returns to its original position when you release it.

•Check that the throttle control and throttle lock move freely and that the return springs work properly.

•Start the chain saw and apply full throttle. Release the throttle control and check that the chain stops and remains stationary. If the chain rotates when the throttle control is in the idle position you should check the carburettor idle adjustment.

Chain catcher

Check that the chain catcher is not damaged and is ﬁrmly attached to the body of the chain saw.

Right hand guard

Check that the right hand guard is not damaged and that there are no visible defects, such as cracks.

Vibration damping system

Regularly check the vibration damping units for cracks or deformation.

Make sure the vibration damping units are securely attached to the engine unit and handle unit.

Stop switch

Start the engine and make sure the engine stops when you move the stop switch to the stop setting.

Mufﬂer

Never use a machine that has a faulty mufﬂer.

Regularly check that the mufﬂer is securely attached to the machine.

English – 9

Image 9

Contents Operator’s manual EPA Key to symbols KEY to SymbolsContents Please read the operator’s manual carefully Before using a new chain sawSafety Instructions Machine′s safety equipmentPersonal protective equipment Chain brake and front hand guard Throttle lock Stop switchChain catcher Right hand guardChecking brake band wear MufﬂerChecking the front hand guard Checking the inertia brake releaseThrottle lock Stop switchChain catcher Right hand guardGeneral rules Cutting equipmentCutting equipment designed to minimise kickback BarSharpening your chain and adjusting raker clearance Some terms that describe the bar and chainGeneral information on sharpening cutting teeth General advice on setting raker clearance Setting the raker clearanceSharpening cutting teeth Lubricating cutting equipment Tensioning the chainChain oil Filling with chain oilLubricating the bar tip sprocket Checking chain lubricationNeedle bearing lubrication Checking wear on cutting equipmentWhat is kickback? How to avoid kickbackGeneral safety precautions Fuel safety StartingTransport and storage General working instructions Basic safety rulesBasic cutting technique GeneralCutting Limbing Tree felling techniqueSafe distance Felling directionDirectional cuts FellingFreeing a tree that has fallen badly General adviceCutting the trunk into logs Freeing a trapped treeWhat is what on the chain saw? What is WHAT?Fitting the bar and chain AssemblyFuel Handling FuelFollowing applies to chain saws with catalytic converters Fuelling Chain oilFuel Handling Starting and stopping Starting and StoppingCold engine Warm engineStopping Carburettor MaintenanceStarter Correctly adjusted carburettorChanging a broken or worn starter cord Tensioning the recoil springSpark plug Air ﬁlterMufﬂer Fitting the starterAir Injection centrifugal cleaning Adjustment of the oil pumpNeedle bearing lubrication Cooling systemTemperature -5C 23 F or colder Temperature 0 C 32 F or colderHeated handles Electrical carburettor heatingWeekly maintenance Daily maintenanceMonthly maintenance Below you will ﬁnd some general maintenance instructionsTechnical data Technical DataBar Chain Length, inches Pitch, inch Max nose radius Your Warranty Rights and Obligations Federal Emission Control Warranty StatementEmission Control Warranty Parts List 1140204-95