Husqvarna 96045000407 Before Starting the Engine, Service REMINDER/HOUR Meter, ADD Gasoline

Page 12

OPERATION

SERVICE REMINDER/HOUR METER

Service reminder shows the total number of hours the engine has run and flashes to indicate that the engine or mower needs servicing. When service is required, the service reminder will flash for two hours. To service engine and mower, see the Maintenance section of this manual.

NOTE: Service reminder runs when the ignition key is in any position but "STOP". For accurate reading, be sure key remains in the "STOP" position when engine is not running.

TOWING CARTS AND OTHER ATTACHMENTS

Tow only the attachments that are recommended by and comply with specifications of the manufacturer of your trac- tor. Use common sense when towing. Too heavy of a load, while on a slope, is dangerous. Tires can lose traction with the ground and cause you to lose control of your tractor.

BEFORE STARTING THE ENGINE

CHECK ENGINE OIL LEVEL

The engine in your tractor has been shipped, from the factory, already filled with summer weight oil.

Check engine oil with tractor on level ground.

Remove oil fill cap/dipstick and wipe clean, reinsert the dipstick and screw cap tight, wait for a few seconds, remove and read oil level. If necessary, add oil until “FULL” mark on dipstick is reached. Do not overfill.

For cold weather operation you should change oil for easier starting (See “OIL VISCOSITY CHART” in the Maintenance section of this manual).

To change engine oil, see the Maintenance section in this manual.

ADD GASOLINE

Fill fuel tank to bottom of filler neck. Do not overfill. Use fresh, clean, regular unleaded gasoline with a minimum of 87 octane. (Use of leaded gasoline will increase carbon and lead oxide deposits and reduce valve life). Do not mix oil with gasoline. Purchase fuel in quantities that can be used within 30 days to assure fuel freshness.

CAUTION: Wipe off any spilled oil or fuel. Do not store, spill or use gasoline near an open flame.

IMPORTANT: WHEN OPERATING IN TEMPERATURES BELOW 32°F(0°C), USE FRESH, CLEAN WINTER GRADE GASOLINE TO HELP INSURE GOOD COLD WEATHER STARTING.

CAUTION: Alcohol blended fuels (called gasohol or using ethanol or methanol) canattract moisturewhich leads to separation and formation of acids during storage. Acidic gas can damage the fuel system of an engine while in storage. To avoid engine problems, the fuel system should be emptied before storage of 30 days or longer. Drain the gas tank, start the engine and let it run until the fuel lines and carburetor are empty. Use fresh fuel next season. See Storage Instructions for additional information. Never use engine or carburetor cleaner products in the fuel tank or permanent damage may occur.

TO START ENGINE (See Fig. 3)

When starting the engine for the first time or if the engine has run out of fuel, it will take extra cranking time to move fuel from the tank to the engine.

Be sure freewheel control is in the transmission engaged position.

Sit on seat in operating position, depress brake pedal and set parking brake.

Move attachment clutch to “DISENGAGED” position.

Move throttle control to choke position.

NOTE: Before starting, read the warm and cold starting procedures below.

Insert key into ignition and turn key clockwise to “START” position and release key as soon as engine starts. Do not run starter continuously for more than fifteen seconds per minute. If the engine does not start after several attempts, move throttle control to fast position, wait a few minutes and try again. If engine still does not start, move the throttle control back to the choke position and retry.

WARM WEATHER STARTING (50° F and above)

When engine starts, move the throttle control to the fast position.

The attachments and ground drive can now be used. If the engine does not accept the load, restart the engine and allow it to warm up for one minute using the choke as described above.

COLD WEATHER STARTING ( 50° F and below)

When engine starts, allow engine to run with the throttle control in the choke position until the engine runs roughly, then move throttle control to fast position. This may re- quire an engine warm-up period from several seconds to several minutes, depending on the temperature.

AUTOMATIC TRANSMISSION WARM UP

Before driving the unit in cold weather, the transmission should be warmed up as follows:

Be sure the tractor is on level ground.

Release the parking brake and let the brake slowly return to operating position.

Allow one minute for transmission to warm up. This can be done during the engine warm up period.

The attachments can also be used during the engine warm-up period after the transmission has been warmed up.

NOTE: If at a high altitude (above 3000 feet) or in cold temperatures (below 32 F) the carburetor fuel mixture may need to be adjusted for best engine performance. See “TO ADJUST CARBURETOR” in the Service and Adjustments section of this manual.

12

Image 12
Contents YTH20K46 Safety Rules Safe Operation Practices for Ride-On MowersGeneral Operation II. Slope OperationService General ServiceIII. Children IV. TowingTable of Contents Assembly Unassembled PartsTo Remove Tractor from Carton Unpack CartonCheck Tire Pressure Check Deck LevelnessCheck for Proper Position of ALL Belts Check Brake SystemOperation Know Your Tractor HOW to USE Your Tractor Attachment Clutch Switch Disengaged EngagedTo SET Parking Brake See Fig Stopping See aTo Adjust Mower Cutting Height See Fig To Adjust Gauge Wheels See FigSystem Characteristics To Move Forward and Backward See FigTo Operate Mower See Fig Reverse Operation System ROS See FigTo Operate on Hills To Transport See FigsService REMINDER/HOUR Meter Before Starting the EngineCheck Engine OIL Level ADD GasolineMowing Tips Purge TransmissionMaintenance Lubrication ChartBattery TractorBlade Care Blade Removal See FigEngine BeltsTransaxle Cooling Transaxle Pump FluidCleaning Service and Adjustments To Install Mower See FigsTo Remove Mower See Fig Slide mower out from under right side of tractorInstall belt on engine pulley M To Level Mower Belt Installation To Replace Mower Blade Drive Belt See FigTo Check Brake To Replace Motion Drive Belt See FigTo Adjust Steering Wheel Alignment To Start Engine with a Weak Battery See FigFront Wheel TOE-IN/CAMBER To Remove Wheel for Repairs See FigTransmission Storage OtherFuel System Engine OILTroubleshooting Points Problem Cause CorrectionEngine dies when Schematic Tractor - Model Number YTH20K46 96045000407, Product no 45Electrical KEY Part Description Chassis 196 532 41 45-80Console Asm. Deck Lift 817 60Drive Drive 817 49Spark Arrester KIT EngineEngine Kohler Model No. SV620 Steering Assembly 532 19 Wheel, Steering Axle Cast Iron Decals Wheels and TiresSeat Assembly 532 40 SeatMower Deck 195145 KEY Part NO. no Description Mower Lift 100Limited Warranty Husqvarna S Obligations Under the Warranty 532 42 20-52 07.30.08 AP

96045000407 specifications

The Husqvarna 96045000407, a powerful and versatile lawn mower, is designed to provide efficiency and superior cutting performance, making it an ideal choice for both residential and professional landscaping. This model features a robust engine that guarantees reliability and power for any mowing task, ensuring a clean and precise cut every time.

One of the standout features of the Husqvarna 96045000407 is its innovative cutting deck design. The mower is equipped with a 42-inch cutting deck that allows for wide, efficient coverage while mowing, reducing the time and effort needed to complete large areas. This deck is crafted from high-quality steel, ensuring durability and long-lasting performance. The adjustable cutting height options give users the flexibility to achieve their desired grass length, promoting a healthy and well-groomed lawn.

Incorporating advanced technology, the Husqvarna 96045000407 employs a robust and efficient engine that provides excellent torque and power, making it suitable for various terrains. The mower's ease of starting is a key feature, thanks to its air-cooled engine that also contributes to reduced emissions and fuel consumption, making it an environmentally friendly choice for lawn care enthusiasts.

Another significant advantage of the Husqvarna 96045000407 is its user-friendly design. With intuitive controls, operators can easily navigate and operate the mower without hassle. The ergonomically designed handle enhances comfort during prolonged use, allowing for better maneuverability. Additionally, this model includes large rear wheels that facilitate easy movement over uneven ground, improving stability and traction.

Versatility is further enhanced by the optional mulching kit, which allows for the clippings to be finely chopped and returned to the lawn as a natural fertilizer, promoting healthy growth. The Husqvarna 96045000407 is not just a mower; it’s a comprehensive lawn care solution tailored for those who demand quality and efficiency in their gardening tasks.

Overall, the Husqvarna 96045000407 stands out with its combination of power, durability, and advanced features. Whether you are a homeowner looking to maintain your lawn or a professional seeking a reliable mowing solution, this model is equipped with the technology and engineering to meet and exceed your expectations, making it a valuable addition to any landscaping toolkit.