Husqvarna 96045000407 owner manual To Adjust Steering Wheel Alignment, Front Wheel TOE-IN/CAMBER

Page 22

SERVICE AND ADJUSTMENTS

TO ADJUST STEERING WHEEL ALIGNMENT

If steering wheel crossbars are not horizontal (left to right) when wheels are positioned straight forward, remove steer- ing wheel and reassemble per instructions in the Assembly section of this manual.

FRONT WHEEL TOE-IN/CAMBER

Your new tractor front wheel toe-in and camber is set at the factory and is normal. The front wheel toe-in and camber are not adjustable. If damage has occurred to affect the factory set front wheel toe-in or camber, contact a qualified service center.

TO REMOVE WHEEL FOR REPAIRS (See Fig. 28)

•Block up axle securely.

•Remove axle cover, retaining ring and washers to allow wheel removal (rear wheel contains a square key - Do not lose).

•Repair tire and reassemble.

•On rear wheels only: align grooves in rear wheel hub and axle. Insert square key.

•Replace washers and snap retaining ring securely in axle groove.

•Replace axle cover.

NOTE: To seal tire punctures and prevent flat tires due to slow leaks, tire sealant may be purchased from your local parts dealer. Tire sealant also prevents tire dry rot and corrosion.

WASHERS

RETAINING

RING

AXLE COVER

SQUARE KEY (REAR

WHEEL ONLY)

FIG. 28

TO START ENGINE WITH A WEAK BATTERY (See Fig. 29)

WARNING: Lead-acid batteries gen- erate explosive gases. Keep sparks, flame and smoking materials away from batteries. Always wear eye protection when around batteries.

If your battery is too weak to start the engine, it should be recharged. (See "BATTERY" in the MAINTENANCE sec- tion of this manual).

If “jumper cables” are used for emergency starting, follow this procedure:

IMPORTANT: YOUR TRACTOR IS EQUIPPED WITH A 12 VOLT SYSTEM. THE OTHER VEHICLE MUST ALSO BE A 12 VOLT SYSTEM. DO NOT USE YOUR TRACTOR BATTERY TO START OTHER VEHICLES.

TO ATTACH JUMPER CABLES -

•Connect one end of the RED cable to the POSITIVE

(+)terminal of each battery(A-B), taking care not to short against tractor chassis.

•Connect one end of the BLACK cable to the NEGATIVE (-) terminal (C) of fully charged battery.

•Connect the other end of the BLACK cable (D) to good chassis ground, away from fuel tank and battery.

TO REMOVE CABLES, REVERSE ORDER -

•BLACK cable first from chassis and then from the fully charged battery.

•RED cable last from both batteries.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

WEAK OR DEAD

 

 

FULLY CHARGED

BATTERY

 

 

BATTERY

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

FIG. 29

22

Page 21 Page 23
Image 22
Page 21 Page 23
Contents YTH20K46 General Operation Safety RulesSafe Operation Practices for Ride-On Mowers II. Slope OperationIII. Children ServiceGeneral Service IV. TowingTable of Contents To Remove Tractor from Carton AssemblyUnassembled Parts Unpack CartonCheck for Proper Position of ALL Belts Check Tire PressureCheck Deck Levelness Check Brake SystemOperation Know Your Tractor To SET Parking Brake See Fig HOW to USE Your TractorAttachment Clutch Switch Disengaged Engaged Stopping See aSystem Characteristics To Adjust Mower Cutting Height See FigTo Adjust Gauge Wheels See Fig To Move Forward and Backward See FigTo Operate on Hills To Operate Mower See FigReverse Operation System ROS See Fig To Transport See FigsCheck Engine OIL Level Service REMINDER/HOUR MeterBefore Starting the Engine ADD GasolineMowing Tips Purge TransmissionMaintenance Lubrication ChartBlade Care BatteryTractor Blade Removal See FigTransaxle Cooling EngineBelts Transaxle Pump FluidCleaning To Remove Mower See Fig Service and AdjustmentsTo Install Mower See Figs Slide mower out from under right side of tractorInstall belt on engine pulley M To Level Mower To Check Brake Belt InstallationTo Replace Mower Blade Drive Belt See Fig To Replace Motion Drive Belt See FigFront Wheel TOE-IN/CAMBER To Adjust Steering Wheel AlignmentTo Start Engine with a Weak Battery See Fig To Remove Wheel for Repairs See FigTransmission Fuel System StorageOther Engine OILTroubleshooting Points Problem Cause CorrectionEngine dies when Schematic Tractor - Model Number YTH20K46 96045000407, Product no 45Electrical KEY Part Description Chassis 196 532 41 45-80Console Asm. Deck Lift 817 60Drive Drive 817 49Spark Arrester KIT EngineEngine Kohler Model No. SV620 Steering Assembly 532 19 Wheel, Steering Axle Cast Iron Decals Wheels and TiresSeat Assembly 532 40 Seat195 Mower Deck145 KEY Part NO. no Description Mower Lift 100Limited Warranty Husqvarna S Obligations Under the Warranty 532 42 20-52 07.30.08 AP

96045000407 specifications

The Husqvarna 96045000407, a powerful and versatile lawn mower, is designed to provide efficiency and superior cutting performance, making it an ideal choice for both residential and professional landscaping. This model features a robust engine that guarantees reliability and power for any mowing task, ensuring a clean and precise cut every time.

One of the standout features of the Husqvarna 96045000407 is its innovative cutting deck design. The mower is equipped with a 42-inch cutting deck that allows for wide, efficient coverage while mowing, reducing the time and effort needed to complete large areas. This deck is crafted from high-quality steel, ensuring durability and long-lasting performance. The adjustable cutting height options give users the flexibility to achieve their desired grass length, promoting a healthy and well-groomed lawn.

Incorporating advanced technology, the Husqvarna 96045000407 employs a robust and efficient engine that provides excellent torque and power, making it suitable for various terrains. The mower's ease of starting is a key feature, thanks to its air-cooled engine that also contributes to reduced emissions and fuel consumption, making it an environmentally friendly choice for lawn care enthusiasts.

Another significant advantage of the Husqvarna 96045000407 is its user-friendly design. With intuitive controls, operators can easily navigate and operate the mower without hassle. The ergonomically designed handle enhances comfort during prolonged use, allowing for better maneuverability. Additionally, this model includes large rear wheels that facilitate easy movement over uneven ground, improving stability and traction.

Versatility is further enhanced by the optional mulching kit, which allows for the clippings to be finely chopped and returned to the lawn as a natural fertilizer, promoting healthy growth. The Husqvarna 96045000407 is not just a mower; it’s a comprehensive lawn care solution tailored for those who demand quality and efficiency in their gardening tasks.

Overall, the Husqvarna 96045000407 stands out with its combination of power, durability, and advanced features. Whether you are a homeowner looking to maintain your lawn or a professional seeking a reliable mowing solution, this model is equipped with the technology and engineering to meet and exceed your expectations, making it a valuable addition to any landscaping toolkit.
Top Page Image Contents