Husqvarna 96045000407 owner manual Storage, Other, Fuel System, Engine OIL, Cylinders

Page 24

STORAGE

Immediately prepare your tractor for storage at the end of the season or if the tractor will not be used for 30 days or more.

WARNING: Never store the tractor with gasoline in the tank inside a building where fumes may reach an open flame or spark. Allow the engine to cool before storing in any enclosure.

TRACTOR

Remove mower from tractor for winter storage. When mower is to be stored for a period of time, clean it thoroughly, remove all dirt, grease, leaves, etc. Store in a clean, dry area.

•Clean entire tractor (See “CLEANING” in the Mainte- nance section of this manual).

•Inspect and replace belts, if necessary (See belt re- placement instructions in the Service and Adjustments section of this manual).

•Lubricate as shown in the Maintenance section of this manual.

•Be sure that all nuts, bolts and screws are securely fastened. Inspect moving parts for damage, breakage and wear. Replace if necessary.

•Touch up all rusted or chipped paint surfaces; sand lightly before painting.

BATTERY

•Fully charge the battery for storage.

•After a period of time in storage, battery may require recharging.

•To help prevent corrosion and power leakage during long periods of storage, battery cables should be dis- connected and battery cleaned thoroughly (See “TO CLEAN BATTERY AND TERMINALS” in the Mainte- nance section of this manual).

•After cleaning, leave cables disconnected and place cables where they cannot come in contact with battery terminals.

•If battery is removed from tractor for storage, do not store battery directly on concrete or damp surfaces.

ENGINE

FUEL SYSTEM

IMPORTANT: IT IS IMPORTANT TO PREVENT GUM DEPOSITS FROM FORMING IN ESSENTIAL FUEL SYSTEM PARTS SUCH AS CARBURETOR, FUEL FILTER, FUEL HOSE, OR TANK DURING STORAGE. ALSO, EXPERIENCE INDICATES THAT ALCOHOL BLENDED FUELS (CALLED GASOHOL OR USING ETHANOL OR METHANOL) CAN ATTRACT MOISTURE WHICH LEADS TO SEPARATION AND FORMATION OF ACIDS DURING STORAGE. ACIDIC GAS CAN DAMAGE THE FUEL SYSTEM OF AN ENGINE WHILE IN STORAGE.

•Empty the fuel tank by starting the engine and let it run until the fuel lines and carburetor are empty.

•Never use engine or carburetor cleaner products in the fuel tank or permanent damage may occur.

•Use fresh fuel next season.

NOTE: Fuel stabilizer is an acceptable alternative in mini- mizing the formation of fuel gum deposits during storage. Add stabilizer to gasoline in fuel tank or storage container. Always follow the mix ratio found on stabilizer container. Run engine at least 10 minutes after adding stabilizer to allow the stabilizer to reach the carburetor. Do not empty the gas tank and carburetor if using fuel stabilizer.

ENGINE OIL

Drain oil (with engine warm) and replace with clean engine oil. (See “ENGINE” in the Maintenance section of this manual).

CYLINDER(S)

•Remove spark plug(s).

•Pour one ounce of oil through spark plug hole(s) into cylinder(s).

•Turn ignition key to “START” position for a few seconds to distribute oil.

•Replace with new spark plug(s).

OTHER

•Do not store gasoline from one season to another.

•Replace your gasoline can if your can starts to rust. Rust and/or dirt in your gasoline will cause problems.

•If possible, store your tractor indoors and cover it to give protection from dust and dirt.

•Cover your tractor with a suitable protective cover that does not retain moisture. Do not use plastic. Plastic cannot breathe which allows condensation to form and will cause your tractor to rust.

IMPORTANT: NEVER COVER TRACTOR WHILE ENGINE AND EXHAUST AREAS ARE STILL WARM.

24

Page 23 Page 25
Image 24
Page 23 Page 25
Contents YTH20K46 Safety Rules Safe Operation Practices for Ride-On MowersGeneral Operation II. Slope OperationService General ServiceIII. Children IV. TowingTable of Contents Assembly Unassembled PartsTo Remove Tractor from Carton Unpack CartonCheck Tire Pressure Check Deck LevelnessCheck for Proper Position of ALL Belts Check Brake SystemOperation Know Your Tractor HOW to USE Your Tractor Attachment Clutch Switch Disengaged EngagedTo SET Parking Brake See Fig Stopping See aTo Adjust Mower Cutting Height See Fig To Adjust Gauge Wheels See FigSystem Characteristics To Move Forward and Backward See FigTo Operate Mower See Fig Reverse Operation System ROS See FigTo Operate on Hills To Transport See FigsService REMINDER/HOUR Meter Before Starting the EngineCheck Engine OIL Level ADD GasolineMowing Tips Purge TransmissionMaintenance Lubrication ChartBattery TractorBlade Care Blade Removal See FigEngine BeltsTransaxle Cooling Transaxle Pump FluidCleaning Service and Adjustments To Install Mower See FigsTo Remove Mower See Fig Slide mower out from under right side of tractorInstall belt on engine pulley M To Level Mower Belt Installation To Replace Mower Blade Drive Belt See FigTo Check Brake To Replace Motion Drive Belt See FigTo Adjust Steering Wheel Alignment To Start Engine with a Weak Battery See FigFront Wheel TOE-IN/CAMBER To Remove Wheel for Repairs See FigTransmission Storage OtherFuel System Engine OILTroubleshooting Points Problem Cause CorrectionEngine dies when Schematic Tractor - Model Number YTH20K46 96045000407, Product no 45Electrical KEY Part Description Chassis 196 532 41 45-80Console Asm. Deck Lift 817 60Drive Drive 817 49Spark Arrester KIT EngineEngine Kohler Model No. SV620 Steering Assembly 532 19 Wheel, Steering Axle Cast Iron Decals Wheels and TiresSeat Assembly 532 40 SeatMower Deck 195145 KEY Part NO. no Description Mower Lift 100Limited Warranty Husqvarna S Obligations Under the Warranty 532 42 20-52 07.30.08 AP

96045000407 specifications

The Husqvarna 96045000407, a powerful and versatile lawn mower, is designed to provide efficiency and superior cutting performance, making it an ideal choice for both residential and professional landscaping. This model features a robust engine that guarantees reliability and power for any mowing task, ensuring a clean and precise cut every time.

One of the standout features of the Husqvarna 96045000407 is its innovative cutting deck design. The mower is equipped with a 42-inch cutting deck that allows for wide, efficient coverage while mowing, reducing the time and effort needed to complete large areas. This deck is crafted from high-quality steel, ensuring durability and long-lasting performance. The adjustable cutting height options give users the flexibility to achieve their desired grass length, promoting a healthy and well-groomed lawn.

Incorporating advanced technology, the Husqvarna 96045000407 employs a robust and efficient engine that provides excellent torque and power, making it suitable for various terrains. The mower's ease of starting is a key feature, thanks to its air-cooled engine that also contributes to reduced emissions and fuel consumption, making it an environmentally friendly choice for lawn care enthusiasts.

Another significant advantage of the Husqvarna 96045000407 is its user-friendly design. With intuitive controls, operators can easily navigate and operate the mower without hassle. The ergonomically designed handle enhances comfort during prolonged use, allowing for better maneuverability. Additionally, this model includes large rear wheels that facilitate easy movement over uneven ground, improving stability and traction.

Versatility is further enhanced by the optional mulching kit, which allows for the clippings to be finely chopped and returned to the lawn as a natural fertilizer, promoting healthy growth. The Husqvarna 96045000407 is not just a mower; it’s a comprehensive lawn care solution tailored for those who demand quality and efficiency in their gardening tasks.

Overall, the Husqvarna 96045000407 stands out with its combination of power, durability, and advanced features. Whether you are a homeowner looking to maintain your lawn or a professional seeking a reliable mowing solution, this model is equipped with the technology and engineering to meet and exceed your expectations, making it a valuable addition to any landscaping toolkit.
Top Page Image Contents