Husqvarna 96043005200 manual To Check Brake, Front Wheel TOE-IN/CAMBER, Fully Charged

Page 22

SERVICE AND ADJUSTMENTS

TO CHECK BRAKE

If tractor requires more than five (5) feet to stop at highest speed in highest gear on a level, dry concrete or paved surface, then brake must be serviced.

You may also check brake by:

•Park tractor on a level, dry concrete or paved surface, depress brake pedal all the way down and engage parking brake.

•Disengage transmission by placing freewheel control in “transmission disengaged” position. Pull freewheel control out and into the slot and release so it is held in the disengaged position.

The rear wheels must lock and skid when you try to manu- ally push the tractor forward. If the rear wheels rotate, then the brake needs to be serviced. Contact a qualified service center.

FRONT WHEEL TOE-IN/CAMBER

Your new tractor front wheel toe-in and camber is set at the factory and is normal. The front wheel toe-in and camber are not adjustable. If damage has occurred to affect the factory set front wheel toe-in or camber, contact a qualified service center.

TO REMOVE WHEEL FOR REPAIRS (See Fig. 27)

•Block up axle securely.

•Remove axle cover, retaining ring and washers to allow wheel removal (rear wheel contains a square key - Do not lose).

•Repair tire and reassemble.

•On rear wheels only: align grooves in rear wheel hub and axle. Insert square key.

•Replace washers and snap retaining ring securely in axle groove.

•Replace axle cover.

NOTE: To seal tire punctures and prevent flat tires due to slow leaks, tire sealant may be purchased from your local parts dealer. Tire sealant also prevents tire dry rot and corrosion.

WASHERS

RETAINING

RING

AXLE COVER

SQUARE KEY (REAR

WHEEL ONLY)

FIG. 27

TO START ENGINE WITH A WEAK BATTERY (See Fig. 28)

WARNING: Lead-acid batteries gen- erate explosive gases. Keep sparks, flame and smoking materials away from batteries. Always wear eye protection when around batteries.

If your battery is too weak to start the engine, it should be recharged. (See "BATTERY" in the MAINTENANCE sec- tion of this manual).

If “jumper cables” are used for emergency starting, follow this procedure:

IMPORTANT: YOUR TRACTOR IS EQUIPPED WITH A 12 VOLT SYSTEM. THE OTHER VEHICLE MUST ALSO BE A 12 VOLT SYSTEM. DO NOT USE YOUR TRACTOR BATTERY TO START OTHER VEHICLES.

TO ATTACH JUMPER CABLES -

•Connect one end of the RED cable to the POSITIVE

(+)terminal of each battery(A-B), taking care not to short against tractor chassis.

•Connect one end of the BLACK cable to the NEGATIVE (-) terminal (C) of fully charged battery.

•Connect the other end of the BLACK cable (D) to good chassis ground, away from fuel tank and battery.

TO REMOVE CABLES, REVERSE ORDER -

•BLACK cable first from chassis and then from the fully charged battery.

•RED cable last from both batteries.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

WEAK OR DEAD

 

 

 

 

 

 

 

FULLY CHARGED

BATTERY

 

 

 

 

 

 

 

BATTERY

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

FIG. 28

22

Page 21 Page 23
Image 22
Page 21 Page 23
Contents YTH 2146 XP CA General Operation Safety RulesSafe Operation Practices for Ride-On Mowers II. Slope OperationIII. Children ServiceGeneral Service IV. TowingTable of Contents To Remove Tractor from Carton AssemblyUnassembled Parts Unpack CartonCheck for Proper Position of ALL Belts Check Tire PressureCheck Deck Levelness Check Brake SystemOperation Know Your Tractor To USE Throttle Control D See Fig HOW to USE Your TractorTo SET Parking BRAKESee Fig Stopping See FigSystem Characteristics To Adjust Mower Cutting Height See FigTo Adjust Gauge Wheels See Fig To Move Forward and Backward See FigReverse Operation System ROS Using the Reverse Operation SystemTo Operate Mower See Fig To Operate on HillsCheck Engine OIL Level Service REMINDER/HOUR MeterBefore Starting the Engine ADD GasolineMowing Tips Purge TransmissionMaintenance Lubrication ChartBlade Care TractorBrake Operation TiresEngine Cleaning To Install Mower See Fig Service and AdjustmentsTo Remove Mower See Fig Service and Adjustments To Level Mower To Replace Mower Drive Belt See Fig To Replace Motion Drive Belt See FigFront Wheel TOE-IN/CAMBER To Start Engine with a Weak Battery See FigTo Check Brake To Remove Wheel for Repairs See FigTo Adjust Carburetor To Adjust Throttle Control CableTo Adjust Choke Control To Replace Headlight BulbFuel System StorageOther Engine OILTroubleshooting Points Problem Cause CorrectionEngine dies when Schematic SCH13Electrical KEY Part Description Chassis 239Tractor - Model Number YTH2146XP 96043005200, Product no 43 Drive 196Tractor - Model Number YTH2146XP 96043005200, Product no 43 Engine Engine Kawa Model No. FH641 Steering Assembly 532 19 Wheel, Steering Seat Assembly 532 40 SeatDecals Wheels and TiresMower Deck KEY Part NO. no Description Mower Lift 100Suggested Guide for Sighting Slopes for Safe Operation 532 41 88-57 12-12-07 SBW

96043005200 specifications

The Husqvarna 96043005200 is a powerful and versatile lawn mower designed to cater to both residential and professional gardening needs. Renowned for its superior engineering, this model stands out due to its combination of cutting-edge technology, innovative design, and reliability.

One of the main features of the Husqvarna 96043005200 is its efficient cutting system. Equipped with a robust engine, it offers a powerful performance that enables it to tackle a variety of grass types and terrains. The mower has an adjustable cutting height, allowing users to customize the grass length according to their preference and the specific requirements of their lawn. With its wide cutting deck, the mower can cover a larger area in shorter time, making lawn care faster and more efficient.

In terms of technology, the Husqvarna 96043005200 incorporates Smart Start technology, which simplifies the starting process. This feature decreases resistance in the starter cord, enabling easy initiation of the engine even after prolonged periods of inactivity. Additionally, it is designed with a compact structure that allows for easy maneuvering around tighter spaces and obstacles in the garden.

Operator comfort is also a priority for the Husqvarna 96043005200. The ergonomic handle is adjustable, ensuring that users of various heights can operate the mower comfortably. Moreover, the design includes vibration dampening technologies, reducing the strain on the operator’s hands and arms during prolonged use. This focus on ergonomics not only enhances comfort but also improves efficiency and productivity.

Durability is another characteristic that makes the Husqvarna 96043005200 a preferred choice among homeowners and professionals alike. The construction materials are robust, ensuring that the mower can withstand the rigors of regular use. It is built to resist wear and tear, providing a reliable performance season after season.

In summary, the Husqvarna 96043005200 is an advanced lawn mower that integrates powerful performance with user-friendly features. Its efficient cutting system, innovative starting technology, ergonomic design, and durability make it an excellent choice for anyone looking to maintain a lush, healthy lawn. This model represents Husqvarna’s commitment to quality and excellence in lawn care equipment, promising users a superior mowing experience.
Top Page Image Contents