Husqvarna 960430172 Transmission REMOVAL/REPLACEMENT, To Adjust Steering Wheel ALIGN- Ment

Page 22

SERVICE AND ADJUSTMENTS

Hold motion control lever in that position and turn engine off.

While holding motion control lever in place, loosen the adjustment bolt.

Move motion control lever to the neutral (N) (lock gate) position.

Tighten adjustment bolt securely.

NOTE: If additional clearance is needed to get to adjustment bolt, move mower deck height to the lowest position.

After above adjustment is made, if the tractor still creeps forward or backward while motion control lever is in neutral position, follow these steps:

Loosen the adjustment bolt.

Move the motion control lever 1/4 to 1/2 inch in the direction it is trying to creep.

Tighten adjustment bolt securely.

Start engine and test.

If tractor still creeps, repeat above steps until satis- fied.

MOTION CONTROL

NEUTRAL

LEVER

LOCK GATE

 

ADJUSTMENT

BOLT

FIG. 23

TRANSMISSION REMOVAL/REPLACEMENT

Should your transmission require removal for service or replacement, it should be purged after reinstallation and before operating the tractor. See“PURGETRANSMISSION” in the Operation section of this manual.

TO ADJUST STEERING WHEEL ALIGN- MENT

If steering wheel crossbars are not horizontal (left to right) when wheels are positioned straight forward, remove steer- ing wheel and reassemble per instructions in the Assembly section of this manual.

FRONT WHEEL TOE-IN/CAMBER

The front wheel toe-in and camber are not adjustable on your tractor.If damage has occurred to affect the front wheel toe-in or camber, contact your nearest authorized service center/department.

TO REMOVE WHEEL FOR REPAIRS (See Fig. 24)

• Block up axle securely.

NOTE: To seal tire punctures and prevent flat tires due to slow leaks, tire sealant may be purchased from your local parts dealer. Tire sealant also prevents tire dry rot and corrosion.

WASHERS

RETAINING

RING

AXLE COVER

SQUARE KEY (REAR

WHEEL ONLY)

FIG. 24

TO START ENGINE WITH A WEAK BATTERY (See Fig. 25)

WARNING: Lead-acid batteries gen- erate explosive gases. Keep sparks, flame and smoking materials away from batteries. Always wear eye protection when around batteries.

If your battery is too weak to start the engine, it should be recharged. (See "BATTERY" in the MAINTENANCE sec- tion of this manual).

If “jumper cables” are used for emergency starting, follow this procedure:

IMPORTANT: YOUR TRACTOR IS EQUIPPED WITH A 12 VOLT SYSTEM. THE OTHER VEHICLE MUST ALSO BE A 12 VOLT SYSTEM. DO NOT USE YOUR TRACTOR BATTERY TO START OTHER VEHICLES.

TO ATTACH JUMPER CABLES -

Connect one end of the RED cable to the POSITIVE

(+)terminal of each battery(A-B), taking care not to short against tractor chassis.

Connect one end of the BLACK cable to the NEGATIVE (-) terminal (C) of fully charged battery.

Connect the other end of the BLACK cable (D) to good chassis ground, away from fuel tank and battery.

TO REMOVE CABLES, REVERSE ORDER -

BLACK cable first from chassis and then from the fully charged battery.

RED cable last from both batteries.

• Remove axle cover, retaining ring and washers to allow wheel removal (rear wheel contains a square key - Do not lose).

• Repair tire and reassemble.

• On rear wheels only: align grooves in rear wheel hub and axle. Insert square key.

• Replace washers and snap retaining ring securely in axle groove.

WEAK OR DEAD BATTERY

FULLY CHARGED

BATTERY

• Replace axle cover.

22

FIG. 25

Image 22
Contents YTH18542 General Operation Safety RulesSafe Operation Practices for Ride-On Mowers II. Slope OperationIII. Children ServiceIV. Towing Table of Contents Steering Wheel Unassembled PartsSeat To Remove Tractor from Carton AssemblyTools Required for Assembly Before Removing Tractor from SkidCheck Battery See Fig Check for Proper Position of ALL Belts Check Tire PressureCheck Deck Levelness Check Brake SystemOperation Know Your Tractor HOW to USE Your Tractor Reverse Operation System ROS To Adjust Gauge Wheels See FigTo Operate Mower See Fig To Operate on HillsCheck Engine OIL Level Before Starting the EngineTo Transport See Figs ADD GasolinePurge Transmission Mowing TipsAutomatic Transmission Warm UP General Recommendations MaintenanceLubrication Chart Before Each USETo Sharpen Blade See Fig TractorBlade Removal See Fig Check Operator Presence SystemEngine Cleaning To Level Mower Housing Service and AdjustmentsTo Install Mower See Fig To Remove Mower See FigTo Replace Mower Blade Drive Belt See Fig Belt InstallationBelt Removal See Fig To Check and Adjust BrakeTransaxle Motion Control Lever Neutral Adjustment See Fig To Replace Motion Drive Belt See FigTo Start Engine with a Weak Battery See Fig Transmission REMOVAL/REPLACEMENTTo Adjust Steering Wheel ALIGN- Ment Front Wheel TOE-IN/CAMBERTo Adjust Carburetor To Adjust Throttle Control CableTo Adjust Choke Control To Replace Headlight BulbFuel System StorageOther Engine OILTroubleshooting Points Engine dies when Schematic TRACTOR-MODEL Number YTH18542 96013000200, Product no 13TRACTOR-MODEL Number YTH18542 96013000200, Product no 13 ElectricalKEY Part NO. NO. Description Chassis TRACTOR-MODEL Number YTH18542 96013000200, Product no 13 Drive TRACTOR-MODEL Number YTH18542 96013000200, Product no 13 Steering Assembly TRACTOR-MODEL Number YTH18542 96013000200, Product no 13 Engine Optional EquipmentMower Lift 1331Seat Assembly Decals Wheels and TiresMower Deck TRACTOR-MODEL Number YTH18542 96013000200, Product no 13 Suggested Guide for Sighting Slopes for Safe Operation Only Ride UP and Down Hill Not Across Hill Degrees MAXWarranty Statement 532 19 49-62 11.2.04 RD

960430172 specifications

The Husqvarna 960430172 is a premium garden tractor designed for those who seek performance, durability, and comfort in lawn care tasks. Known for its robust build and efficient features, this model stands out in the market for homeowners and professionals alike.

One of the primary characteristics of the Husqvarna 960430172 is its powerful engine. Equipped with a reliable Briggs & Stratton engine, it delivers excellent cutting performance, allowing users to tackle various lawn conditions effortlessly. The engine’s high torque and efficient fuel consumption provide long-lasting power while ensuring that the tractor can handle even the toughest grass. A convenient automatic transmission enhances the user experience by allowing for smooth and easy operation without the hassle of manual gear shifting.

The cutting deck is another highlight of the Husqvarna 960430172. With a cutting width of 42 inches, it ensures that users cover large areas in minimal time. The deck is made from durable materials designed to withstand regular wear and tear, while the effective mowing height adjustment allows for precision lawn care tailored to individual preferences. Additionally, the Air Induction mowing technology further enhances performance by improving grass lift for a clean and even cut.

Ergonomics is a significant focus in the design of the Husqvarna 960430172. The tractor features a comfortable, high-back seat with armrests, allowing for long hours of mowing without discomfort. The steering wheel is positioned for optimal control, making it easy to navigate challenging terrains. Its tight turning radius enhances maneuverability around flower beds and landscaping features, making it an ideal choice for complex yards.

The Husqvarna 960430172 also boasts advanced safety features. An integrated safety switch ensures that the mower cannot operate unless the operator is seated, reducing the risk of accidents. Easy-access controls and a clear dashboard contribute to user-friendly handling, while the sturdy construction ensures stability in various conditions.

In conclusion, the Husqvarna 960430172 garden tractor offers an impressive array of features and technologies tailored for effective lawn maintenance. Its powerful engine, durable cutting deck, ergonomic design, and safety features combine to deliver a superior mowing experience, making it a valuable addition to any homeowner’s gardening toolkit. With this tractor, users can expect reliability and performance that meets their lawn care needs with ease.