Husqvarna 960430172 Before Starting the Engine, To Transport See Figs, Check Engine OIL Level

Page 13

OPERATION

Ifstoppingisabsolutelynecessary,pushclutch/brakepedal quickly to brake position and engage parking brake.

Move motion control lever to neutral (N) position.

IMPORTANT: THE MOTION CONTROL LEVER DOES NOT RETURN TO NEUTRAL (N) POSITION WHEN THE CLUTCH/ BRAKE PEDAL IS DEPRESSED.

To restart movement, slowly release parking brake and clutch/brake pedal.

Slowly move motion control lever to slowest setting.

Make all turns slowly.

TO TRANSPORT (See Figs. 4 and 8)

When pushing or towing your tractor, be sure to disengage transmission by placing freewheel control in freewheeling position. Free wheel control is located at the rear drawbar of tractor.

Raise attachment lift to highest position with attachment lift control.

Pull freewheel control out and down into the slot and release so it is held in the disengaged position.

Do not push or tow tractor at more than two (2) MPH.

To reengage transmission, reverse above procedure.

NOTE: To protect hood from damage when transporting your tractor on a truck or a trailer, be sure hood is closed and secured to tractor. Use an appropriate means of tying hood to tractor (rope, cord, etc.).

Transmission Engaged

Transmission Disengaged

FIG. 8

TOWING CARTS AND OTHER ATTACHMENTS

Tow only the attachments that are recommended by and comply with specifications of the manufacturer of your trac- tor. Use common sense when towing. Too heavy of a load, while on a slope, is dangerous. Tires can lose traction with the ground and cause you to lose control of your tractor.

BEFORE STARTING THE ENGINE

CHECK ENGINE OIL LEVEL

The engine in your tractor has been shipped, from the factory, already filled with summer weight oil.

Check engine oil with tractor on level ground.

Remove oil fill cap/dipstick and wipe clean, reinsert the dipstick and screw cap tight, wait for a few seconds, remove and read oil level. If necessary, add oil until “FULL” mark on dipstick is reached. Do not overfill.

For cold weather operation you should change oil for easier starting (See “OIL VISCOSITY CHART” in the Maintenance section of this manual).

To change engine oil, see the Maintenance section in

this manual.

13

ADD GASOLINE

Fill fuel tank to bottom of filler neck. Do not overfill. Use fresh, clean, regular unleaded gasoline with a minimum of 87 octane. (Use of leaded gasoline will increase carbon and lead oxide deposits and reduce valve life). Do not mix oil with gasoline. Purchase fuel in quantities that can be used within 30 days to assure fuel freshness.

CAUTION: Wipe off any spilled oil or fuel. Do not store, spill or use gasoline near an open flame.

IMPORTANT: WHEN OPERATING IN TEMPERATURES BELOW32°F(0°C), USE FRESH, CLEAN WINTER GRADE GASOLINE TO HELP INSURE GOOD COLD WEATHER STARTING.

CAUTION: Alcohol blended fuels (called gasohol or using ethanol or methanol) can attract moisture which leads to separation and formation of acids during storage. Acidic gas can damage the fuel system of an engine while in storage. To avoid engine problems, the fuel system should be emptied before storage of 30 days or longer. Drain the gas tank, start the engine and let it run until the fuel lines and carburetor are empty. Use fresh fuel next season. See Storage Instructions for additional information. Never use engine or carburetor cleaner products in the fuel tank or permanent damage may occur.

TO START ENGINE (See Fig. 4)

When starting the engine for the first time or if the engine has run out of fuel, it will take extra cranking time to move fuel from the tank to the engine.

Be sure freewheel control is in the transmission engaged position.

Sit on seat in operating position, depress clutch/brake pedal and set parking brake.

Place motion control lever in neutral (N) position.

Move attachment clutch to “DISENGAGED” position.

Move throttle control to choke position.

NOTE: Before starting, read the warm and cold starting procedures below.

Insert key into ignition and turn key clockwise to“START” position and release key as soon as engine starts. Do not run starter continuously for more than fifteen seconds per minute. If the engine does not start after several attempts, move throttle control to fast position, wait a few minutes and try again. If engine still does not start, move the throttle control back to the choke position and retry.

WARM WEATHER STARTING (50° F and above)

When engine starts, move the throttle control to the fast position.

Image 13
Contents YTH18542 Safe Operation Practices for Ride-On Mowers Safety RulesGeneral Operation II. Slope OperationIII. Children ServiceIV. Towing Table of Contents Steering Wheel Unassembled PartsSeat Tools Required for Assembly AssemblyTo Remove Tractor from Carton Before Removing Tractor from SkidCheck Battery See Fig Check Deck Levelness Check Tire PressureCheck for Proper Position of ALL Belts Check Brake SystemOperation Know Your Tractor HOW to USE Your Tractor To Operate Mower See Fig To Adjust Gauge Wheels See FigReverse Operation System ROS To Operate on HillsTo Transport See Figs Before Starting the EngineCheck Engine OIL Level ADD GasolinePurge Transmission Mowing TipsAutomatic Transmission Warm UP Lubrication Chart MaintenanceGeneral Recommendations Before Each USEBlade Removal See Fig TractorTo Sharpen Blade See Fig Check Operator Presence SystemEngine Cleaning To Install Mower See Fig Service and AdjustmentsTo Level Mower Housing To Remove Mower See FigTo Replace Mower Blade Drive Belt See Fig Belt InstallationBelt Removal Transaxle Motion Control Lever Neutral Adjustment See Fig To Check and Adjust BrakeSee Fig To Replace Motion Drive Belt See FigTo Adjust Steering Wheel ALIGN- Ment Transmission REMOVAL/REPLACEMENTTo Start Engine with a Weak Battery See Fig Front Wheel TOE-IN/CAMBERTo Adjust Choke Control To Adjust Throttle Control CableTo Adjust Carburetor To Replace Headlight BulbOther StorageFuel System Engine OILTroubleshooting Points Engine dies when TRACTOR-MODEL Number YTH18542 96013000200, Product no 13 SchematicElectrical TRACTOR-MODEL Number YTH18542 96013000200, Product no 13KEY Part NO. NO. Description Chassis TRACTOR-MODEL Number YTH18542 96013000200, Product no 13 Drive TRACTOR-MODEL Number YTH18542 96013000200, Product no 13 Steering Assembly TRACTOR-MODEL Number YTH18542 96013000200, Product no 13 Optional Equipment Engine1331 Mower LiftSeat Assembly Wheels and Tires DecalsMower Deck TRACTOR-MODEL Number YTH18542 96013000200, Product no 13 Only Ride UP and Down Hill Not Across Hill Degrees MAX Suggested Guide for Sighting Slopes for Safe OperationWarranty Statement 532 19 49-62 11.2.04 RD

960430172 specifications

The Husqvarna 960430172 is a premium garden tractor designed for those who seek performance, durability, and comfort in lawn care tasks. Known for its robust build and efficient features, this model stands out in the market for homeowners and professionals alike.

One of the primary characteristics of the Husqvarna 960430172 is its powerful engine. Equipped with a reliable Briggs & Stratton engine, it delivers excellent cutting performance, allowing users to tackle various lawn conditions effortlessly. The engine’s high torque and efficient fuel consumption provide long-lasting power while ensuring that the tractor can handle even the toughest grass. A convenient automatic transmission enhances the user experience by allowing for smooth and easy operation without the hassle of manual gear shifting.

The cutting deck is another highlight of the Husqvarna 960430172. With a cutting width of 42 inches, it ensures that users cover large areas in minimal time. The deck is made from durable materials designed to withstand regular wear and tear, while the effective mowing height adjustment allows for precision lawn care tailored to individual preferences. Additionally, the Air Induction mowing technology further enhances performance by improving grass lift for a clean and even cut.

Ergonomics is a significant focus in the design of the Husqvarna 960430172. The tractor features a comfortable, high-back seat with armrests, allowing for long hours of mowing without discomfort. The steering wheel is positioned for optimal control, making it easy to navigate challenging terrains. Its tight turning radius enhances maneuverability around flower beds and landscaping features, making it an ideal choice for complex yards.

The Husqvarna 960430172 also boasts advanced safety features. An integrated safety switch ensures that the mower cannot operate unless the operator is seated, reducing the risk of accidents. Easy-access controls and a clear dashboard contribute to user-friendly handling, while the sturdy construction ensures stability in various conditions.

In conclusion, the Husqvarna 960430172 garden tractor offers an impressive array of features and technologies tailored for effective lawn maintenance. Its powerful engine, durable cutting deck, ergonomic design, and safety features combine to deliver a superior mowing experience, making it a valuable addition to any homeowner’s gardening toolkit. With this tractor, users can expect reliability and performance that meets their lawn care needs with ease.