Husqvarna 960430173 owner manual Before Starting the Engine, Check Engine OIL Level, ADD Gasoline

Page 12

OPERATION

BEFORE STARTING THE ENGINE

CHECK ENGINE OIL LEVEL

The engine in your tractor has been shipped, from the factory, already filled with summer weight oil.

•Check engine oil with tractor on level ground.

•Remove oil fill cap/dipstick and wipe clean, reinsert the dipstick and screw cap tight, wait for a few seconds, remove and read oil level. If necessary, add oil until “FULL” mark on dipstick is reached. Do not overfill.

•For cold weather operation you should change oil for easier starting (See “OIL VISCOSITY CHART” in the Maintenance section of this manual).

•To change engine oil, see the Maintenance section in this manual.

ADD GASOLINE

•Fill fuel tank to bottom of filler neck. Do not overfill. Use fresh, clean, regular unleaded gasoline with a minimum of 87 octane. (Use of leaded gasoline will increase carbon and lead oxide deposits and reduce valve life). Do not mix oil with gasoline. Purchase fuel in quantities that can be used within 30 days to assure fuel freshness.

CAUTION: Wipe off any spilled oil or fuel. Do not store, spill or use gasoline near an open flame.

IMPORTANT: WHEN OPERATING IN TEMPERATURES BELOW 32°F(0°C), USE FRESH, CLEAN WINTER GRADE GASOLINE TO HELP ENSURE GOOD COLD WEATHER STARTING.

CAUTION: Alcohol blended fuels (called gasohol or using ethanol or methanol) can attract moisture which leads to separation and formation of acids during storage. Acidic gas can damage the fuel system of an engine while in storage. To avoid engine problems, the fuel system should be emptied before storage of 30 days or longer. Drain the gas tank, start the engine and let it run until the fuel lines and carburetor are empty. Use fresh fuel next season. See Storage Instructions for additional information. Never use engine or carburetor cleaner products in the fuel tank or permanent damage may occur.

TO START ENGINE (See Fig. 3)

When starting the engine for the first time or if the engine has run out of fuel, it will take extra cranking time to move fuel from the tank to the engine.

•Be sure freewheel control is in the transmission engaged position.

•Sit on seat in operating position, depress brake pedal and set parking brake.

•Move attachment clutch to “DISENGAGED” position.

•Move throttle control to fast position

•Pull choke control out for a cold engine start attempt. For a warm engine start attempt the choke control may not be needed.

NOTE: Before starting, read the warm and cold starting procedures below.

•Insert key into ignition and turn key clockwise to “START” position and release key as soon as engine starts. Do not run starter continuously for more than fifteen seconds per minute. If the engine does not start after several attempts, push choke control in, wait a few minutes and try again. If engine still does not start, pull the choke control out and retry.

WARM WEATHER STARTING (50°F (10°C and above)

•When engine starts, slowly push choke control in until the engine begins to run smoothly. If the engine starts to run roughly, pull the choke control out slightly for a few seconds and then continue to push the control in slowly.

•The attachments and ground drive can now be used. If the engine does not accept the load, restart the engine and allow it to warm up for one minute using the choke as described above.

COLD WEATHER STARTING (50°F (10°C and below)

•When engine starts, slowly push choke control in until the engine begins to run smoothly. Continue to push the choke control in small steps allowing the engine to accept small changes in speed and load, until the choke control is fully in. If the engine starts to run roughly, pull the choke control out slightly for a few seconds and then continue to push the control in slowly. This may require an engine warm-up period from several seconds to several minutes, depending on the temperature.

AUTOMATIC TRANSMISSION WARM UP

•Before driving the unit in cold weather, the transmission should be warmed up as follows:

•Be sure the tractor is on level ground.

•Release the parking brake and let the brake slowly return to operating position.

•Allow one minute for transmission to warm up. This can be done during the engine warm up period.

•The attachments can be used during the engine warm- up period after the transmission has been warmed up and may require the choke control be pulled out slightly.

NOTE: If at a high altitude (above 3000 feet) or in cold temperatures (below 32° F /0°C) the carburetor fuel mixture may need to be adjusted for best engine performance. See “TO ADJUST CARBURETOR” in the Service and Adjust- ments section of this manual.

12

Page 11 Page 13
Image 12
Page 11 Page 13
Contents YTH22V42 Safety Rules Safe Operation Practices for Ride-On MowersGeneral Service III. ChildrenSafe Handling of Gasoline Table of Contents Tools Required for Assembly ToremovetractorfromcartonBefore Removing Tractor from Skid Unpack CartonCheck Tire Pressure Check Deck LevelnessCheck for Proper Position of ALL Belts Check Brake SystemOperation Know Your Tractor HOW to USE Your Tractor To Adjust Mower Cutting Height See Fig To Adjust Gauge Wheels See FigTo USE Cruise Control J See Fig To Operate MowerService REMINDER/HOUR Meter Using the Reverse Operation SystemReverse Operation System ROS To Operate on HillsBefore Starting the Engine Check Engine OIL LevelADD Gasoline To Start Engine See FigMowing Tips Purge TransmissionRunning Maintenance Lubrication ChartGeneral Recommendations ScheduleBattery TractorBlade Care Blade Removal See FigEngine Cleaning MufflerIN-LINE Fuel Filter See Fig Deck Washout Port See FigTo Install Mower See Fig To Remove Mower See FigInstall belt on engine pulley M, in belt keepers G To Level Mower Belt Installation To Replace Mower Blade Drive Belt See FigTo Check Brake To Replace Motion Drive Belt See FigTo Start Engine with a Weak Battery See Fig Replacing Battery See FigTo Remove Wheel See Fig Front Wheel TOE-IN/CAMBERTransmission Other Fuel SystemEngine OIL CylindersProblem Cause Correction To run when oper Battery will notFires when turn Engine continuesSchematic Tractor - Model Number YTH22V42 96043010000, Product no 43Electrical KEY Part Description Chassis Tractor - Model Number YTH22V42 96043010000, Product no 43 Drive Washer Harden .793 x 1.637 x Engine Engine Power Rating Information Steering Assembly Tractor - Model Number YTH22V42 96043010000, Product no 43 Mower Deck 532 40 Mower Housing KEY Part NO. NO. DescriptionMower Lift 100 101Seat Assembly 532 42 SeatDecals Wheels and TiresSuggested Guide for Sighting Slopes for Safe Operation Only Ride UP and Down Hill Not Across Hill Degrees MAX02.13.12 JA/TH

960430173 specifications

The Husqvarna 960430173 is a versatile and powerful lawn mower designed for both residential and semi-professional use. With its robust construction and high-performance features, this mower is ideal for tackling a variety of lawn care tasks efficiently.

One of the standout characteristics of the Husqvarna 960430173 is its cutting system. This mower features a durable steel cutting deck that comes in various sizes, allowing users to choose the perfect width for their mowing needs. The optimally designed blades ensure a clean and precise cut, promoting healthy grass growth. Its adjustable cutting height provides flexibility, allowing users to customize the grass length according to their preferences.

Equipped with advanced technology, this model features a reliable and efficient engine that delivers powerful performance. The engine is designed for smooth operation, ensuring that the mower can handle tough conditions without compromising on power. Moreover, its fuel-efficient design reduces the frequency of refueling, making it more convenient for users.

The Husqvarna 960430173 is also designed with user comfort in mind. It boasts ergonomic handles that provide a comfortable grip, reducing fatigue during extended mowing sessions. The mower’s lightweight design facilitates easy maneuverability, allowing users to navigate around tight corners and obstacles within the yard.

Another notable feature of this mower is its innovative safety mechanisms. The mower is equipped with a blade brake system that stops the blades quickly when the user releases the handle, enhancing safety while in operation. This feature is particularly important for households with children or pets.

For those who appreciate technological advancements, the Husqvarna 960430173 offers compatibility with smart technology solutions. Certain models can be paired with Husqvarna's smart garden solutions, providing users with real-time information about their lawn care needs through a smartphone application. This feature allows for better lawn management and optimization of maintenance schedules.

In conclusion, the Husqvarna 960430173 is a powerful lawn mower that combines efficiency, comfort, and advanced technology. Its high-quality construction ensures durability, while its user-friendly features make lawn care a breeze. Whether for residential use or semi-professional applications, this mower delivers exceptional performance, making it a valuable tool for any lawn enthusiast.
Top Page Image Contents