Husqvarna 960430173 To Remove Wheel See Fig, Front Wheel TOE-IN/CAMBER, Replacing Battery See Fig

Page 22

SERVICE AND ADJUSTMENTS

TO REMOVE WHEEL (See Fig. 32)

•Block up axle securely.

•Remove axle cover, retaining ring and washers to allow wheel removal (rear wheel contains a square key - Do not lose).

•Repair tire and reassemble.

•On rear wheels only: align grooves in rear wheel hub and axle. Insert square key.

•Replace washers and snap retaining ring securely in axle groove.

•Replace axle cover.

NOTE: To seal tire punctures and prevent flat tires due to slow leaks, tire sealant may be purchased from your local parts dealer. Tire sealant also prevents tire dry rot and corrosion.

RETAINING WASHERS

RING

AXLE

COVER

SQUARE KEY (REAR

WHEEL ONLY)

Fig. 32

FRONT WHEEL TOE-IN/CAMBER

Your new tractor front wheel toe-in and camber is set at the factory and is normal. The front wheel toe-in and camber are not adjustable. If damage has occurred to affect the factory set front wheel toe-in or camber, contact a qualified service center.

TO START ENGINE WITH A WEAK BATTERY (See Fig. 33)

WARNING: Lead-acid batteries generate explosive gases. Keep sparks, flame and smoking materials away from batteries. Always wear eye protection when around batteries.

If your battery is too weak to start the engine, it should be recharged. (See "BATTERY" in the MAINTENANCE sec- tion of this manual).

If “jumper cables” are used for emergency starting, follow this procedure:

IMPORTANT: YOUR TRACTOR IS EQUIPPED WITH A 12 VOLT SYSTEM. THE OTHER VEHICLE MUST ALSO BE A 12 VOLT SYSTEM. DO NOT USE YOUR TRACTOR BATTERY TO START OTHER VEHICLES.

TO ATTACH JUMPER CABLES -

•Connect one end of the RED cable to the POSITIVE

(+)terminal of each battery(A-B), taking care not to short against tractor chassis.

•Connect one end of the BLACK cable to the NEGATIVE (-) terminal (C) of fully charged battery.

•Connect the other end of the BLACK cable (D) to good chassis ground, away from fuel tank and battery.

TO REMOVE CABLES, REVERSE ORDER -

•BLACK cable first from chassis and then from the fully charged battery.

•RED cable last from both batteries.

WEAK OR

FULLY CHARGED

DEAD BATTERY

BATTERY

Fig. 33

REPLACING BATTERY (See Fig. 34)

WARNING: Do not short battery termi- nals by allowing a wrench or any other object to contact both terminals at the same time. Before connecting battery, remove metal bracelets, wristwatch bands, rings, etc. Positive terminal must be connected first to prevent sparking from accidental grounding.

•Lift seat pan to raised position.

•Disconnect BLACK battery cable first then RED battery cable and carefully remove battery from tractor.

•Install new battery with terminals in same position as old battery.

•First connect RED battery cable to positive (+) terminal with bolt and nut as shown. Tighten securely. Slide terminal cover over terminal.

•Connect BLACK grounding cable to negative (-) ter- minal with remaining bolt and nut. Tighten securely.

•Lower seat pan.

SEAT PAN

 

TERMINAL

NUT

COVER

BOLT

 

POSITIVE

NEGATIVE

(RED)

(BLACK)

CABLE

CABLE

02603

 

Fig. 34

22

Page 21 Page 23
Image 22
Page 21 Page 23
Contents YTH22V42 Safety Rules Safe Operation Practices for Ride-On MowersIII. Children General ServiceSafe Handling of Gasoline Table of Contents Before Removing Tractor from Skid Tools Required for AssemblyToremovetractorfromcarton Unpack CartonCheck for Proper Position of ALL Belts Check Tire PressureCheck Deck Levelness Check Brake SystemOperation Know Your Tractor HOW to USE Your Tractor To USE Cruise Control J See Fig To Adjust Mower Cutting Height See FigTo Adjust Gauge Wheels See Fig To Operate MowerReverse Operation System ROS Service REMINDER/HOUR MeterUsing the Reverse Operation System To Operate on HillsADD Gasoline Before Starting the EngineCheck Engine OIL Level To Start Engine See FigPurge Transmission Mowing TipsRunning General Recommendations MaintenanceLubrication Chart ScheduleBlade Care BatteryTractor Blade Removal See FigEngine IN-LINE Fuel Filter See Fig CleaningMuffler Deck Washout Port See FigTo Install Mower See Fig To Remove Mower See FigInstall belt on engine pulley M, in belt keepers G To Level Mower To Check Brake Belt InstallationTo Replace Mower Blade Drive Belt See Fig To Replace Motion Drive Belt See FigTo Remove Wheel See Fig To Start Engine with a Weak Battery See FigReplacing Battery See Fig Front Wheel TOE-IN/CAMBERTransmission Engine OIL OtherFuel System CylindersProblem Cause Correction Fires when turn To run when operBattery will not Engine continuesSchematic Tractor - Model Number YTH22V42 96043010000, Product no 43Electrical KEY Part Description Chassis Tractor - Model Number YTH22V42 96043010000, Product no 43 Drive Washer Harden .793 x 1.637 x Engine Engine Power Rating Information Steering Assembly Tractor - Model Number YTH22V42 96043010000, Product no 43 Mower Deck 532 40 Mower Housing KEY Part NO. NO. DescriptionMower Lift 100 101Seat Assembly 532 42 SeatDecals Wheels and TiresSuggested Guide for Sighting Slopes for Safe Operation Only Ride UP and Down Hill Not Across Hill Degrees MAX02.13.12 JA/TH

960430173 specifications

The Husqvarna 960430173 is a versatile and powerful lawn mower designed for both residential and semi-professional use. With its robust construction and high-performance features, this mower is ideal for tackling a variety of lawn care tasks efficiently.

One of the standout characteristics of the Husqvarna 960430173 is its cutting system. This mower features a durable steel cutting deck that comes in various sizes, allowing users to choose the perfect width for their mowing needs. The optimally designed blades ensure a clean and precise cut, promoting healthy grass growth. Its adjustable cutting height provides flexibility, allowing users to customize the grass length according to their preferences.

Equipped with advanced technology, this model features a reliable and efficient engine that delivers powerful performance. The engine is designed for smooth operation, ensuring that the mower can handle tough conditions without compromising on power. Moreover, its fuel-efficient design reduces the frequency of refueling, making it more convenient for users.

The Husqvarna 960430173 is also designed with user comfort in mind. It boasts ergonomic handles that provide a comfortable grip, reducing fatigue during extended mowing sessions. The mower’s lightweight design facilitates easy maneuverability, allowing users to navigate around tight corners and obstacles within the yard.

Another notable feature of this mower is its innovative safety mechanisms. The mower is equipped with a blade brake system that stops the blades quickly when the user releases the handle, enhancing safety while in operation. This feature is particularly important for households with children or pets.

For those who appreciate technological advancements, the Husqvarna 960430173 offers compatibility with smart technology solutions. Certain models can be paired with Husqvarna's smart garden solutions, providing users with real-time information about their lawn care needs through a smartphone application. This feature allows for better lawn management and optimization of maintenance schedules.

In conclusion, the Husqvarna 960430173 is a powerful lawn mower that combines efficiency, comfort, and advanced technology. Its high-quality construction ensures durability, while its user-friendly features make lawn care a breeze. Whether for residential use or semi-professional applications, this mower delivers exceptional performance, making it a valuable tool for any lawn enthusiast.
Top Page Image Contents