Husqvarna 6522CH owner manual Engine, AIR Filter, Muffler, Spark Plug, Cleaning

Page 12

CUSTOMER RESPONSIBILITIES

ENGINE

LUBRICATION

Use only high quality detergent oil rated with API service classification SF - SJ. Select the oil's SAE viscosity grade according to your expected operating temperature.

SAE VISCOSITY GRADES

 

 

 

 

 

 

 

 

 

 

 

SAE 30

 

 

 

 

 

 

 

5W-30

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

°F

-20°

 

 

30° 32° 40°

 

 

60°

80°

 

100°

°C

-30°

-20°

-10°

10°

20°

30°

40°

TEMPERATURE RANGE ANTICIPATED BEFORE NEXT OIL CHANGE

NOTE: Although multi-viscosity oils (5W30, 10W30 etc.) improve starting in cold weather, these multi-viscosity oils will result in increased oil consumption when used above 32°F. Check your engine oil level more frequently to avoid possible engine damage from running low on oil.

Change the oil after every 25 hours of operation or at least once a year if the lawn mower is not used for 25 hours in one year.

Check the crankcase oil level before starting the engine and after each five (5) hours of continuous use. Tighten oil plug securely each time you check the oil level.

TO CHANGE ENGINE OIL (See Fig. 11)

NOTE: Before tipping lawn mower to drain oil, drain fuel tank by running engine until fuel tank is empty.

1.Disconnect spark plug wire from spark plug and place wire where it cannot come in contact with spark plug.

2.Remove engine oil cap; lay aside on a clean surface.

3.Tip lawn mower on its side as shown and drain oil into a suitable container. Rock lawn mower back and forth to remove any oil trapped inside of engine.

4.Wipe off any spilled oil on lawn mower and on side of engine.

5.Fill engine with oil. (See “Add Oil” in the Operacion section of this manual.)

6.Reconnect spark plug wire to spark plug.

CONTAINER

FIG. 11

AIR FILTER

Your engine will not run properly and may be damaged by using a dirty air filter.

Replace the air filter every year, more often if you mow in very dusty, dirty conditions. Do not wash air filter.

To change air filter, see engine manual.

MUFFLER

Inspect and replace corroded muffler as it could create a fire hazard and/or damage.

SPARK PLUG

Change your spark plug each year to make your engine start easier and run better. Set spark plug gap at .030 inch.

CLEANING

IMPORTANT: FOR BEST PERFORMANCE, KEEP MOWER HOUSING FREE OF BUILT-UP GRASS AND TRASH. CLEAN THE UNDERSIDE OF YOUR MOWER AFTER EACH USE.

CAUTION: Disconnect spark plug wire from spark plug and place wire where it cannot come in contact with the spark plug.

Clean the underside of your lawn mower by scraping to remove build-up of grass and trash.

Clean engine often to keep trash from accumulating. A clogged engine runs hotter and shortens engine life.

Keep finished surfaces and wheels free of all gasoline, oil,etc.

We do not recommend using a garden hose to clean lawn mower unless the electrical system, muffler, air filter and carburetor are covered to keep water out. Water in engine can result in shortened engine life.

12

Image 12
Contents 6522CH IV. Service Safe Operation Practices for Walk-Behind MowersGeneral Operation II. Slope OperationTable of Contents Warranty Statement Assembly HOW to SET UP Your Lawn MowerTo Install Attachments To Remove Lawn Mower from CartonMeets Cpsc Safety Requirements OperationKnow Your Lawn Mower To Adjust Cutting Height See Fig Engine Speed See FigEngine Zone Control Drive Control See FigSimple Steps to Remember When Converting Your Lawn Mower Before Starting EngineTo Empty Grass Catcher See Fig ADD OIL See FigADD Gasoline See Fig To Start Engine See FigTo Stop Engine Mowing TipsGeneral Recommendations Lubrication Chart Maintenance ScheduleCustomer Responsibilities Before Each USELawn Mower Cleaning EngineAIR Filter MufflerService and Adjustments Storage OtherFuel System Engine OILTroubleshooting Points Problem Cause CorrectionRotary Lawn Mower Model Number 6522CH 6522CHA KEY Part Description Repair Parts KEY Part NO. NO. Description Gear Case Assembly Part Number